Corrected QT Interval (QTc) Calculator
Correct a measured QT interval for heart rate with four common formulas side by side.
Enter the values and click Calculate.
About this calculator
The QT interval gets shorter as the heart rate goes up, so it is corrected to a heart rate of 60 beats/min before it is compared with a normal range. No single formula is perfect: Bazett over-corrects at fast rates and under-corrects at slow rates, so the other formulas are shown for comparison.
What you need
- QT interval in milliseconds, measured on the ECG from the start of the QRS complex to the end of the T wave. Use the same lead each time and average several beats; a typical QT at rest is about 350 to 440 ms depending on rate.
- Heart rate in beats per minute from the same tracing, typically 60 to 100 at rest.
Formula
RR (s) = 60 / heart rate.
Bazett: QTc = QT / sqrt(RR).
Fridericia: QTc = QT / RR^(1/3).
Framingham: QTc = QT + 154 x (1 - RR).
Hodges: QTc = QT + 1.75 x (heart rate - 60).
Typical reference values
Many sources treat a QTc above about 450 ms in men and 460 to 470 ms in women as prolonged, and a QTc above 500 ms as a marked risk for torsades de pointes. Use the limits set by your local protocol or by the drug's labelling.
Worked example
QT 400 ms at 75 beats/min gives RR = 0.8 s. Bazett 447 ms, Fridericia 431 ms, Framingham 431 ms, Hodges 426 ms.
Common mistakes
- Relying on Bazett at very fast or very slow heart rates, where it over- and under-corrects; that is why the other three formulas are shown.
- Measuring the QT in different leads on different occasions and comparing the results.
- Including a U wave in the measurement, which overestimates QT.
- Applying the formulas in atrial fibrillation, bundle branch block or ventricular pacing, where beat-to-beat variation or a wide QRS makes a single QTc misleading.
Limitations
Not reliable in atrial fibrillation, ventricular pacing, bundle branch block or very fast or slow rates without careful measurement. Measure QT in the same lead and average several beats.
Frequently asked questions
Which formula should I use?
Follow your laboratory or protocol. Bazett is the most common but the least accurate at rate extremes; Fridericia and Framingham behave better there, and Hodges is also used. Comparing all four, as this page does, shows how much the choice matters for a given tracing.
What QTc is dangerous?
Many sources flag a QTc above about 450 ms in men and 460 to 470 ms in women as prolonged, and above 500 ms as carrying a markedly increased risk of torsades de pointes. Drug labelling often uses its own thresholds.
Why does heart rate matter at all?
The QT naturally shortens as the heart beats faster, so a raw QT cannot be compared between rates. Correction expresses what the QT would be at 60 beats/min.
Reference
- Bazett HC. An analysis of the time-relations of electrocardiograms. Heart 1920;7:353-370.
- Fridericia LS. Die Systolendauer im Elektrokardiogramm bei normalen Menschen und bei Herzkranken. Acta Med Scand 1920;53:469-486.
- Sagie A, Larson MG, Goldberg RJ, et al. An improved method for adjusting the QT interval for heart rate (the Framingham Heart Study). Am J Cardiol 1992;70:797-801.
- Hodges M, Salerno D, Erlien D. Bazett's QT correction reviewed. J Am Coll Cardiol 1983;1:694.
Disclaimer. Medical information only. This calculator is an educational aid for clinicians and students. It does not give medical advice, diagnosis or treatment, and it does not replace clinical judgment. Check results against the original source and local protocols before using them in patient care.