LDL Cholesterol Calculator (Sampson and Friedewald)


Estimate LDL cholesterol from a standard lipid panel using the Sampson/NIH equation (accurate even with triglycerides up to 800 mg/dL) or the classic Friedewald equation.

Enter the lipid panel and pick an equation tab.

Sampson (NIH) equation

Enter your values:
Results:

What this calculator is and when it is used

Low-density lipoprotein cholesterol (LDL-C) drives cardiovascular risk and treatment targets. Laboratories usually estimate it from total cholesterol, HDL cholesterol and triglycerides rather than measuring it directly. The Sampson (NIH) equation, published in 2020, is more accurate than the older Friedewald equation when triglycerides are high or LDL is low, and stays usable up to triglycerides of 800 mg/dL.

Use it on a fasting or non-fasting standard lipid panel when a calculated LDL is wanted. A directly measured LDL is preferred when triglycerides are very high or precision matters.

What you need to enter

  • Total cholesterol, HDL cholesterol and triglycerides from the same sample, in mg/dL or mmol/L (the unit boxes convert).
  • Choose the equation tab: Sampson (recommended, valid to triglycerides 800 mg/dL) or Friedewald (classic, valid only below 400 mg/dL and least accurate when LDL is low).

How to read the result

Calculated LDL-CUsual guideline band (NCEP ATP III)
Below 100 mg/dL (2.6 mmol/L)Optimal for most adults. Treatment targets in high-risk patients are lower (below 70 or 55 mg/dL); compare the result with the target for the patient's risk category.
100 to 129 mg/dLNear or above optimal.
130 to 159 mg/dLBorderline high; risk assessment and lifestyle measures, medication per overall risk.
160 to 189 mg/dLHigh; guidelines generally recommend medication discussion.
190 mg/dL or moreVery high; requires clinician assessment of overall risk and possible familial hypercholesterolemia.

Formulas

Sampson/NIH: LDL-C = TC/0.948 - HDL/0.971 - (TG/8.56 + TG x non-HDL/2140 - TG^2/16100) - 9.44, where non-HDL = TC - HDL. Friedewald: LDL-C = TC - HDL - TG/5. All values in mg/dL.

Worked example

Total cholesterol 200 mg/dL, HDL 50 mg/dL, triglycerides 150 mg/dL. Sampson: 200/0.948 - 50/0.971 - (150/8.56 + 150 x 150/2140 - 150^2/16100) - 9.44 = 123.4 mg/dL. Friedewald: 200 - 50 - 30 = 120 mg/dL.

Limitations

  • No equation is reliable above triglycerides of 800 mg/dL (Sampson) or 400 mg/dL (Friedewald); order a direct LDL measurement there.
  • Results are less reliable in type III dysbetalipoproteinemia and immediately after acute illness.
  • The Martin/Hopkins adjustable-factor method is not included: permission and factor-table implementation have not yet been verified for this site, so this page offers the openly published Sampson equation instead.

Reference

  • Sampson M, Ling C, Sun Q, et al. A new equation for calculation of low-density lipoprotein cholesterol in patients with normolipidemia and/or hypertriglyceridemia. JAMA Cardiol 2020;5(5):540-548. doi:10.1001/jamacardio.2020.0013
  • Friedewald WT, Levy RI, Fredrickson DS. Estimation of the concentration of low-density lipoprotein cholesterol in plasma, without use of the preparative ultracentrifuge. Clin Chem 1972;18(6):499-502.

Disclaimer. Medical information only. This calculator is an educational aid for clinicians and students. It does not give medical advice, diagnosis or treatment, and it does not replace clinical judgment. Check results against the original source and local protocols before using them in patient care.

Northwell Health laboratory equation implementation notice

Sampson et al., original LDL equation study, 2020