Corrected Calcium for Albumin Calculator


Adjust a total serum calcium result for the albumin level to estimate what the calcium would be with normal albumin.

Enter the values and click Calculate.

Introduzca los valores:
Resultados:

About this calculator

About 40 percent of calcium in blood is bound to albumin, so a low albumin lowers the total calcium without changing the active (ionized) calcium. This formula adds back 0.8 mg/dL for every 1 g/dL that albumin is below 4.0 g/dL.

What you need

  • Total serum calcium from a blood test, in mg/dL or mmol/L; a typical reference range is about 8.5 to 10.5 mg/dL (2.2 to 2.6 mmol/L).
  • Serum albumin from the same or a recent sample, in g/dL or g/L; a typical range is about 3.5 to 5.0 g/dL (35 to 50 g/L). The formula assumes 4.0 g/dL is normal.

Formula

Corrected calcium (mg/dL) = measured calcium + 0.8 x (4.0 - albumin in g/dL).

How to read the result

The corrected value is read against the usual calcium range of about 8.5 to 10.5 mg/dL. Below the range suggests true hypocalcemia, above it suggests hypercalcemia. If correcting for albumin moves the result across a boundary, or the patient is critically ill, the more reliable next step is a direct ionized calcium measurement rather than further arithmetic.

Worked example

Calcium 8.0 mg/dL with albumin 2.5 g/dL: 8.0 + 0.8 x 1.5 = 9.2 mg/dL.

Common mistakes

  • Applying the correction when albumin is normal; it changes nothing by design.
  • Trusting the estimate in critical illness, kidney disease or acid-base disturbance, where binding shifts unpredictably and ionized calcium is the better test.
  • Mixing albumin units: 4.0 g/dL equals 40 g/L, and entering one as the other breaks the formula. Use the unit box.

Limitations

The correction is a rough estimate and can be wrong in critical illness, kidney disease and acid-base disorders. When it matters, measure ionized calcium.

Frequently asked questions

Why correct calcium for albumin?

About 40% of blood calcium rides on albumin. When albumin falls, total calcium falls with it even though the active, ionized fraction may be normal. The correction estimates what the total would be at a normal albumin.

When should I skip the formula?

Whenever the answer changes management and the patient is unwell: measure ionized calcium instead.

Reference

  • Payne RB, Little AJ, Williams RB, Milner JR. Interpretation of serum calcium in patients with abnormal serum proteins. Br Med J 1973;4(5893):643-646. doi:10.1136/bmj.4.5893.643

Disclaimer. Medical information only. This calculator is an educational aid for clinicians and students. It does not give medical advice, diagnosis or treatment, and it does not replace clinical judgment. Check results against the original source and local protocols before using them in patient care.