Shaft Combined Bending and Torsion Calculator


Check a round shaft under combined bending and torsion, or find the diameter you need. Uses von Mises / maximum-shear theory for checking and the ASME shaft equation with shock and fatigue factors for sizing.

Enter loads and shaft data. Moments: N·mm = kN·m x 1,000,000.

Check diameter

값을 입력하세요:

ASME: 1.0 steady, 1.5-2.0 minor shock, 2.0-3.0 heavy shock.

ASME: 1.0 steady, 1.0-1.5 minor shock, 1.5-3.0 heavy shock.

결과:

How it works

Nominal stresses in a solid round shaft: σ(b) = 32M/πd³ and τ = 16T/πd³. Checking applies von Mises (σ' = √(σ²+3τ²)) and Tresca (τ(max) = √((σ/2)²+τ²)) with your K factors applied. Sizing uses the ASME code equation d³ = (16/πτ(allow))·√((K(b)M)² + (K(t)T)²).

  • For hollow shafts the same equations apply with the section properties of the annulus; this tool assumes solid circular section.
  • ASME allowable shear stress: the least of 0.30×yield or 0.18×ultimate, reduced by 25% if a keyway is present.
  • Bending moment from belt/gear loads: combine vectorially if loads act in different planes.

Static analysis only. For rotating shafts with fluctuating loads run a fatigue check (Goodman/Soderberg) and check critical speed separately.