Corrected Count Increment (CCI) for Platelet Transfusion


Judge the response to a platelet transfusion: the corrected count increment (CCI) adjusts the platelet rise for body size and dose. Below about 5,000 at 10 to 60 minutes suggests platelet refractoriness.

Enter the counts, body size and dose, then click Calculate.

Insira os valores:
10^9/L
10^9/L
x 10^11

About 3 for a standard apheresis unit; check the product label.

Resultados:

What this calculator is and when it is used

After a platelet transfusion the platelet count should rise. How much it should rise depends on the patient's size and the dose given. The corrected count increment (CCI) divides the measured rise by the number of platelets transfused and scales it by body surface area, so different patients and doses can be compared.

Use it on a post-transfusion platelet count drawn 10 to 60 minutes after the infusion ends. A poor response on two or more occasions defines platelet refractoriness and triggers a work-up for immune and non-immune causes.

What you need to enter

  • Pre-transfusion platelet count: the most recent count before the transfusion, in 10^9/L (same as 10^3/µL).
  • Post-transfusion platelet count: drawn 10 to 60 minutes after the transfusion, in 10^9/L.
  • Height and weight: used for the Mosteller body surface area. Enter in cm and kg, or in/lb (the unit boxes convert).
  • Platelets transfused: the platelet content of the product, in units of 10^11 platelets. A single donor apheresis unit typically contains about 3 x 10^11; check the product label.

How to read the result

ResultWhat it usually means and the next consideration
CCI 5,000 or more (10-60 min)Meets the 5,000 threshold used here. A good increment does not exclude platelet dysfunction or other causes of bleeding.
CCI below 5,000 (10-60 min)Suggests refractoriness if seen on two or more transfusions. Some guidelines use 7,500 at 1 hour or 4,500 at 24 hours as the cut-off. Next: rule out fever, sepsis, splenomegaly, bleeding, DIC and drugs; test for HLA and HPA antibodies and consider HLA-matched or crossmatch-compatible platelets.

Formula

CCI (per µL) = (post count - pre count) in 10^9/L x 1000 x body surface area in m^2 / platelets transfused in 10^11. Body surface area uses the Mosteller formula: BSA = square root of (height in cm x weight in kg / 3600).

Worked example

A patient 170 cm tall and 70 kg (BSA 1.82 m^2) goes from 20 to 45 x 10^9/L after a product containing 3 x 10^11 platelets. CCI = 25 x 1000 x 1.82 / 3, about 15,200. That is a good response.

Limitations

  • A 24-hour CCI is normally lower than a 1-hour CCI even with a good response; use the timing-matched threshold.
  • The product's actual platelet content varies; using the labeled content matters.
  • Fever, sepsis, active bleeding, splenomegaly and some drugs lower the increment without immune refractoriness.

Reference

  • New Zealand Blood Service. Guidelines for the management of patients refractory to platelet transfusion (111G002). CCI formula, 10-60 minute post count and the 5,000/µL threshold.
  • Mosteller RD. Simplified calculation of body-surface area. N Engl J Med 1987;317(17):1098. doi:10.1056/NEJM198710223171717

Disclaimer. Medical information only. This calculator is an educational aid for clinicians and students. It does not give medical advice, diagnosis or treatment, and it does not replace clinical judgment. Check results against the original source and local protocols before using them in patient care.

New Zealand Blood Service platelet refractoriness guideline