Parkland Formula Burn Fluid Calculator


Estimate crystalloid volume for the first 24 hours after a burn from weight and the percentage of total body surface area burned.

Enter the values and click Calculate.

Insira os valores:
% TBSA

Do not count first-degree burns.

Resultados:
mL
mL
mL/h
mL
mL/h

About this calculator

The Parkland formula was one of the first guides for giving fluid after major burns. Half of the 24-hour volume is given in the first 8 hours counted from the time of the burn, not from arrival, and the rest over the next 16 hours.

What you need

  • Body weight in kg or lb, measured or estimated on arrival.
  • Burn size as the percentage of total body surface area covered by second-degree (partial thickness) and third-degree (full thickness) burns, estimated with a Lund-Browder chart or the rule of nines. First-degree areas are not counted.
  • The mL per kg per %TBSA factor. 4 mL is the classic Parkland value; some guidelines start at 2 or 3 mL and titrate to urine output. Follow your burn protocol.

Formula

24-hour volume = 4 mL x body weight (kg) x % total body surface area burned.

Half in the first 8 hours after injury, half over the following 16 hours. The mL per kg per % factor is shown as a choice because some guidelines start lower and adjust to urine output.

Targets

The formula is a starting point. Adjust the rate hourly to urine output (about 0.5 mL/kg/h in adults, about 1 mL/kg/h in small children). The Parkland volume uses lactated Ringer's solution.

How to read the result

The total is the crystalloid target for the first 24 hours after the burn. Half runs in the first 8 hours counted from the time of injury, not from hospital arrival, and the other half over the next 16 hours. The figures are a starting point: the rate is then adjusted hour by hour to urine output, about 0.5 mL/kg/h in adults and about 1 mL/kg/h in small children, with a burn centre involved early.

Worked example

A 70 kg adult with 30% TBSA burns: 4 x 70 x 30 = 8400 mL in 24 hours. 4200 mL in the first 8 hours (525 mL/h) and 4200 mL over the next 16 hours (262.5 mL/h).

Common mistakes

  • Counting the 8-hour window from arrival instead of from the time of the burn.
  • Including first-degree (red, non-blistering) areas in the TBSA estimate.
  • Running the calculated rate unchanged for 24 hours; the formula starts resuscitation, and urine output steers it after that.
  • Using the formula alone for electrical, inhalation or very deep injuries, which often need more fluid and specialist care.

Limitations

Over-resuscitation and under-resuscitation both cause harm. Children, electrical or inhalation injury and delayed presentation need special care. Time already elapsed since the burn is not subtracted here.

Frequently asked questions

Which fluid does the formula assume?

Lactated Ringer's solution, the standard resuscitation crystalloid for burns.

What if some of the first 8 hours have already passed?

The first-half volume still aims to be completed by 8 hours from the injury, so the hourly rate is raised to catch up; this page shows the unadjusted schedule.

Reference

  • Baxter CR, Shires T. Physiological response to crystalloid resuscitation of severe burns. Ann N Y Acad Sci 1968;150(3):874-894.
  • American Burn Association. Advanced Burn Life Support course provider manual (current edition).

Disclaimer. Medical information only. This calculator is an educational aid for clinicians and students. It does not give medical advice, diagnosis or treatment, and it does not replace clinical judgment. Check results against the original source and local protocols before using them in patient care.