Injection Molding Runner and Gate Sizing Calculator


First-pass sizing of a cold runner and edge gate: runner diameter from shot weight and runner length, gate depth from part wall thickness and material factor, gate width from the part surface area.

Enter the shot, runner and part details. Empirical shop-floor proportions.

Insira os valores:
Resultados:

How it works

Runner diameter from the common shop relation D = √W × L0.25 / 3.7 (W = shot weight in g, L = runner length in mm). Edge gate: depth h = n·t (t = wall thickness) and width w = n·√A / 30 (A = part surface area in mm²), with n the material constant. Keep gate land around 0.5-1 mm.

  • Full-round runners give the best flow; trapezoidal runners use a similar cross-section area.
  • These are starting proportions: gate freeze time and shear rate decide the final size - grow the gate in trials if filling is short or pressure high.
  • For high-viscosity or filled materials open the gate one step; for multi-cavity tools balance the runner first.

Rule-of-thumb sizing in line with common molding handbooks; confirm with mold-flow analysis for critical parts.