Nivel 7


14 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.

Introduzca los valores:
Resultados:
%

Answers and sources

Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.

Question 1: answer and source

An antenna that radiates uniformly in all directions is called

Answer: Isotropic Antenna

Isotropic radiator/antenna: radiates uniformly in all directions (reference antenna).

Source 1

Question 2: answer and source

Interlacing is used in T.V because

Answer: It reduces flicker

Interlaced scanning doubles the perceived frame rate and reduces flicker without extra bandwidth.

Source 1

Question 3: answer and source

UHF signals normally propagates by means of

Answer: Space Wave

UHF propagates mainly by the space wave (direct + ground-reflected, line-of-sight).

Source 1

Question 4: answer and source

The function of pre-emphasis circuit in a communication system is to boost

Answer: The higher audio frequencies

Pre-emphasis boosts the higher (audio) frequencies before transmission to improve SNR.

Source 1

Question 5: answer and source

Armstrong modulator generates

Answer: FM

Armstrong's indirect method generates wideband FM from a narrowband phase/frequency modulator plus multipliers.

Source 1

Question 6: answer and source

Tropospheric scatter is used in the following range

Answer: UHF

Troposcatter uses 'radio waves at UHF and SHF frequencies' (~300 MHz-5 GHz). Legacy key 'VHF' wrong; correct is UHF.

Source 1

Question 7: answer and source

The F.M signal is passed through frequency tripler, the resultant modulation index will change by a factor of

Answer: 3

Working: a frequency tripler multiplies the deviation by 3, so the modulation index m = delta_f/f_m also triples.

Source 1

Question 8: answer and source

Quantization noise occurs in

Answer: PCM

Quantization noise arises in PCM when amplitudes are rounded to discrete levels.

Source 1

Question 9: answer and source

Blind speed problem in a radar can be effectively overcome by using

Answer: Variable PRF

MTI blind speeds occur at integer multiples of the PRF Doppler line; varying the PRF moves the blind speeds so targets are not lost.

Source 1

Question 10: answer and source

To represent a decimal number 35 in binary, the minimum number of bits required are

Answer: 6

Working: 35 = 100011b (32+2+1); 2^5 = 32 <= 35 < 64 = 2^6, so 6 bits minimum.

Source 1

Question 11: answer and source

To add the binary number 1101 with 1111 one needs

Answer: Three full adder with one half adder

Working: 4-bit addition - LSB stage has no carry-in (half adder); the remaining three stages need full adders.

Source 1

Question 12: answer and source

To measure high Q inductors, the bridge preferred is

Answer: Hay's Bridge

Hay's bridge is the preferred bridge for high-Q inductors (complement of the Maxwell bridge for low Q).

Source 1

Question 13: answer and source

The voltage gain of an amplifier used with Boolstrap sweep theoretically shall be

Answer: +1

Bootstrap sweep: the feedback amplifier makes v_a equal to the capacitor voltage, requiring voltage gain of exactly unity (+1).

Source 1

Question 14: answer and source

In grid bias modulation system the power needed for modulating amplifier

Answer: Is small as compared to that for plate modulation

Control-grid modulation is a low-level scheme chosen when minimum modulator power is desired - far less than for plate modulation.

Source 1

Change log: 17 November 2026

Original question numbers and review decisions
  • Original Q1: verified. Isotropic radiator/antenna: radiates uniformly in all directions (reference antenna).
  • Original Q2: dropped. Excluded from release because available support was insufficient.
  • Original Q3: dropped. Indian analogue television used different channel widths across bands/systems; the stem does not specify System B.
  • Original Q4: verified. Interlaced scanning doubles the perceived frame rate and reduces flicker without extra bandwidth.
  • Original Q5: dropped. This symptom set can have multiple causes; the repair page does not establish one unique diagnosis.
  • Original Q6: dropped. The propagation source could not be retrieved; the single-cause claim was not independently verified.
  • Original Q7: verified. UHF propagates mainly by the space wave (direct + ground-reflected, line-of-sight).
  • Original Q8: dropped. The cited transmitter notes could not be retrieved; leave this row out rather than rely on a generic label.
  • Original Q9: dropped. The root-sum-square index assumes distinct tone frequencies and a particular total-index definition not stated in the stem.
  • Original Q10: verified. Pre-emphasis boosts the higher (audio) frequencies before transmission to improve SNR.
  • Original Q11: verified. Armstrong's indirect method generates wideband FM from a narrowband phase/frequency modulator plus multipliers.
  • Original Q12: dropped. The cited article supports a particular receiver modification, not the broad claim about commonly used SSB generation filters.
  • Original Q13: corrected. Troposcatter uses 'radio waves at UHF and SHF frequencies' (~300 MHz-5 GHz). Legacy key 'VHF' wrong; correct is UHF.
  • Original Q14: dropped. The cited discussion could not be retrieved (403); the named tuning function was not independently checked.
  • Original Q15: dropped. The source discusses audio fidelity but does not establish primary dependence on that stage rather than IF bandwidth for all receivers.
  • Original Q16: dropped. Noise source predominance is system-dependent; the cited lecture does not establish the universal answer.
  • Original Q17: verified. Working: a frequency tripler multiplies the deviation by 3, so the modulation index m = delta_f/f_m also triples.
  • Original Q18: verified. Quantization noise arises in PCM when amplitudes are rounded to discrete levels.
  • Original Q19: verified. MTI blind speeds occur at integer multiples of the PRF Doppler line; varying the PRF moves the blind speeds so targets are not lost.
  • Original Q20: dropped. Radar range scaling needs fixed wavelength, power, losses and other parameters; they are unstated and the options contain duplicates.
  • Original Q21: verified. Working: 35 = 100011b (32+2+1); 2^5 = 32 <= 35 < 64 = 2^6, so 6 bits minimum.
  • Original Q22: verified. Working: 4-bit addition - LSB stage has no carry-in (half adder); the remaining three stages need full adders.
  • Original Q23: verified. Hay's bridge is the preferred bridge for high-Q inductors (complement of the Maxwell bridge for low Q).
  • Original Q24: verified. Bootstrap sweep: the feedback amplifier makes v_a equal to the capacitor voltage, requiring voltage gain of exactly unity (+1).
  • Original Q25: dropped. The selected output list omits the carrier even though the explanation says the carrier is present.
  • Original Q26: dropped. The answer assumes 75 kHz permitted deviation, which is not specified and is not universal.
  • Original Q27: dropped. Doubling bandwidth is only an approximation; Carson bandwidth also includes the unchanged 10 kHz modulation frequency.
  • Original Q28: dropped. A superheterodyne local oscillator can use high-side or low-side injection, so always higher is false.
  • Original Q29: dropped. Exact duplicate of Q18 in this level ('Quantization noise occurs in / PCM'). Removed to avoid repetition.
  • Original Q30: verified. Control-grid modulation is a low-level scheme chosen when minimum modulator power is desired - far less than for plate modulation.
  • Original Q31: dropped. Switching speed depends on device and circuit details; the source does not prove a universal MOSFET ranking over every listed device.