Stufe 7


14 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.

Geben Sie Ihre Werte ein:
Ergebnisse:
%

Answers and sources

Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.

Question 1: answer and source

An antenna that radiates uniformly in all directions is called

Answer: Isotropic Antenna

Isotropic radiator/antenna: radiates uniformly in all directions (reference antenna).

Source 1

Question 2: answer and source

Interlacing is used in T.V because

Answer: It reduces flicker

Interlaced scanning doubles the perceived frame rate and reduces flicker without extra bandwidth.

Source 1

Question 3: answer and source

UHF signals normally propagates by means of

Answer: Space Wave

UHF propagates mainly by the space wave (direct + ground-reflected, line-of-sight).

Source 1

Question 4: answer and source

The function of pre-emphasis circuit in a communication system is to boost

Answer: The higher audio frequencies

Pre-emphasis boosts the higher (audio) frequencies before transmission to improve SNR.

Source 1

Question 5: answer and source

Armstrong modulator generates

Answer: FM

Armstrong's indirect method generates wideband FM from a narrowband phase/frequency modulator plus multipliers.

Source 1

Question 6: answer and source

Tropospheric scatter is used in the following range

Answer: UHF

Troposcatter uses 'radio waves at UHF and SHF frequencies' (~300 MHz-5 GHz). Legacy key 'VHF' wrong; correct is UHF.

Source 1

Question 7: answer and source

The F.M signal is passed through frequency tripler, the resultant modulation index will change by a factor of

Answer: 3

Working: a frequency tripler multiplies the deviation by 3, so the modulation index m = delta_f/f_m also triples.

Source 1

Question 8: answer and source

Quantization noise occurs in

Answer: PCM

Quantization noise arises in PCM when amplitudes are rounded to discrete levels.

Source 1

Question 9: answer and source

Blind speed problem in a radar can be effectively overcome by using

Answer: Variable PRF

MTI blind speeds occur at integer multiples of the PRF Doppler line; varying the PRF moves the blind speeds so targets are not lost.

Source 1

Question 10: answer and source

To represent a decimal number 35 in binary, the minimum number of bits required are

Answer: 6

Working: 35 = 100011b (32+2+1); 2^5 = 32 <= 35 < 64 = 2^6, so 6 bits minimum.

Source 1

Question 11: answer and source

To add the binary number 1101 with 1111 one needs

Answer: Three full adder with one half adder

Working: 4-bit addition - LSB stage has no carry-in (half adder); the remaining three stages need full adders.

Source 1

Question 12: answer and source

To measure high Q inductors, the bridge preferred is

Answer: Hay's Bridge

Hay's bridge is the preferred bridge for high-Q inductors (complement of the Maxwell bridge for low Q).

Source 1

Question 13: answer and source

The voltage gain of an amplifier used with Boolstrap sweep theoretically shall be

Answer: +1

Bootstrap sweep: the feedback amplifier makes v_a equal to the capacitor voltage, requiring voltage gain of exactly unity (+1).

Source 1

Question 14: answer and source

In grid bias modulation system the power needed for modulating amplifier

Answer: Is small as compared to that for plate modulation

Control-grid modulation is a low-level scheme chosen when minimum modulator power is desired - far less than for plate modulation.

Source 1

Change log: 17 November 2026

Original question numbers and review decisions
  • Original Q1: verified. Isotropic radiator/antenna: radiates uniformly in all directions (reference antenna).
  • Original Q2: dropped. Excluded from release because available support was insufficient.
  • Original Q3: dropped. Indian analogue television used different channel widths across bands/systems; the stem does not specify System B.
  • Original Q4: verified. Interlaced scanning doubles the perceived frame rate and reduces flicker without extra bandwidth.
  • Original Q5: dropped. This symptom set can have multiple causes; the repair page does not establish one unique diagnosis.
  • Original Q6: dropped. The propagation source could not be retrieved; the single-cause claim was not independently verified.
  • Original Q7: verified. UHF propagates mainly by the space wave (direct + ground-reflected, line-of-sight).
  • Original Q8: dropped. The cited transmitter notes could not be retrieved; leave this row out rather than rely on a generic label.
  • Original Q9: dropped. The root-sum-square index assumes distinct tone frequencies and a particular total-index definition not stated in the stem.
  • Original Q10: verified. Pre-emphasis boosts the higher (audio) frequencies before transmission to improve SNR.
  • Original Q11: verified. Armstrong's indirect method generates wideband FM from a narrowband phase/frequency modulator plus multipliers.
  • Original Q12: dropped. The cited article supports a particular receiver modification, not the broad claim about commonly used SSB generation filters.
  • Original Q13: corrected. Troposcatter uses 'radio waves at UHF and SHF frequencies' (~300 MHz-5 GHz). Legacy key 'VHF' wrong; correct is UHF.
  • Original Q14: dropped. The cited discussion could not be retrieved (403); the named tuning function was not independently checked.
  • Original Q15: dropped. The source discusses audio fidelity but does not establish primary dependence on that stage rather than IF bandwidth for all receivers.
  • Original Q16: dropped. Noise source predominance is system-dependent; the cited lecture does not establish the universal answer.
  • Original Q17: verified. Working: a frequency tripler multiplies the deviation by 3, so the modulation index m = delta_f/f_m also triples.
  • Original Q18: verified. Quantization noise arises in PCM when amplitudes are rounded to discrete levels.
  • Original Q19: verified. MTI blind speeds occur at integer multiples of the PRF Doppler line; varying the PRF moves the blind speeds so targets are not lost.
  • Original Q20: dropped. Radar range scaling needs fixed wavelength, power, losses and other parameters; they are unstated and the options contain duplicates.
  • Original Q21: verified. Working: 35 = 100011b (32+2+1); 2^5 = 32 <= 35 < 64 = 2^6, so 6 bits minimum.
  • Original Q22: verified. Working: 4-bit addition - LSB stage has no carry-in (half adder); the remaining three stages need full adders.
  • Original Q23: verified. Hay's bridge is the preferred bridge for high-Q inductors (complement of the Maxwell bridge for low Q).
  • Original Q24: verified. Bootstrap sweep: the feedback amplifier makes v_a equal to the capacitor voltage, requiring voltage gain of exactly unity (+1).
  • Original Q25: dropped. The selected output list omits the carrier even though the explanation says the carrier is present.
  • Original Q26: dropped. The answer assumes 75 kHz permitted deviation, which is not specified and is not universal.
  • Original Q27: dropped. Doubling bandwidth is only an approximation; Carson bandwidth also includes the unchanged 10 kHz modulation frequency.
  • Original Q28: dropped. A superheterodyne local oscillator can use high-side or low-side injection, so always higher is false.
  • Original Q29: dropped. Exact duplicate of Q18 in this level ('Quantization noise occurs in / PCM'). Removed to avoid repetition.
  • Original Q30: verified. Control-grid modulation is a low-level scheme chosen when minimum modulator power is desired - far less than for plate modulation.
  • Original Q31: dropped. Switching speed depends on device and circuit details; the source does not prove a universal MOSFET ranking over every listed device.