Livello 6
30 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.
Answers and sources
Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.
Question 1: answer and source
In order to have the impulse response of a control system approaching zero with the time tending to infinity
Answer: The poles of the system must lie on the L.H.S of the S-plane
Stability/decaying impulse response needs all poles in the left half of the s-plane; key unchanged. Fixed misprints 'apporaching'/'position'.
Question 2: answer and source
For an ideal noise free amplifier, the noise figure is
Answer: Zero dB
Ideal noise-free amplifier: noise factor F = 1, i.e. noise figure 0 dB; key unchanged.
Question 3: answer and source
Wide bandwidth operation is offered by
Answer: Common Base Amplifier
The common-base stage is free of Miller-effect capacitance multiplication and is known for wider bandwidth than CE; legacy keyed 'Common Collector'.
Question 4: answer and source
When a junction is formed between a metal and a semiconductor, the depletion layer is
Answer: Less on the side of the metal
The depletion region sits almost entirely in the semiconductor, so it is less on the metal side; key unchanged.
Question 5: answer and source
In the negative feedback amplifier with gain A / K, the noise generated in the amplifier is reduced by a factor of
Answer: K
Negative feedback reduces internally generated noise by the same desensitivity factor (1 + AB) = K by which it reduces gain; legacy keyed 1/K.
Question 6: answer and source
The type of negative feedback which results in the increase of both Zin and Zout of an amplifier is
Answer: Current-Series
Series mixing raises input impedance; current sampling raises output impedance; key unchanged.
Question 7: answer and source
Zener diodes are used in
Answer: Voltage Regulators
Zener breakdown gives a stable reference voltage for regulation; key unchanged.
Question 8: answer and source
In a saturated transistor
Answer: Both the junctions are forward biased
Saturation: both emitter and collector junctions are forward biased; key unchanged.
Question 9: answer and source
A good current amplifier has the following property
Answer: Low Rin and high Rout
A current amplifier should take current in (low Rin) and drive current out (high Rout); key unchanged.
Question 10: answer and source
A silicon transistor at a temperature of 25 Degrees C has leakage current Icbo of 10 microamps. If the temperature rises to 55 Degrees C the leakage current would be
Answer: 80 microamps
Icbo doubles about every 10 degrees C: 10 -> 20 -> 40 -> 80 microamps over 30 degrees; key unchanged.
Question 11: answer and source
The oscillator that has the best frequency stability is
Answer: Crystal Oscillator
Crystal oscillators have the highest Q and best frequency stability; key unchanged.
Question 12: answer and source
All the components in a parallel resonant circuit are ideal. The value of Q is
Answer: R / WL
For a parallel resonant circuit Q = R/(omega L) (= omega C R); WL/R is the series-circuit form; legacy keyed WL/R. Fixed misprint 'paralled'.
Question 13: answer and source
Bootstrap sweep circuit generally employs
Answer: Emitter Follower
A bootstrap sweep uses an emitter follower to feed the output back to the charging resistor; key unchanged.
Question 14: answer and source
In the design of composite filter, the end half m-derived section are included to
Answer: Realize constant value of characteristic impedance over operating frequency
M-derived half sections at the ends keep the image impedance nearly constant over the pass band; key unchanged.
Question 15: answer and source
The condition for a distortionless transmission line is
Answer: LG = RC
Heaviside's distortionless condition: L/R = C/G, i.e. LG = RC; key unchanged.
Question 16: answer and source
Crystal oscillators are preferred to LC oscillators due to their
Answer: Frequency Stability
The crystal's very high Q gives superior frequency stability; key unchanged.
Question 17: answer and source
In class B push pull amplifier, the cross-over distortion is eliminated by
Answer: Adopting class AB operation
A small standing bias (class AB) removes the dead zone that causes crossover distortion; key unchanged.
Question 18: answer and source
In the hybrid parameters representing the two port network, the parameters represent
Answer: Combination of the above
h-parameters mix impedance (h11), admittance (h22) and dimensionless ratios (h12, h21); key unchanged.
Question 19: answer and source
A band pass filter is usually designed as follows
Answer: Low pass filter followed by a high pass filter
A wide band-pass is built by cascading a low-pass and a high-pass section; legacy keyed 'series tuned circuit'. Fixed misprint 'paralled'.
Question 20: answer and source
The radiation resistance of a half wave dipole antenna in free space
Answer: 73 Ohms
Half-wave dipole radiation resistance is about 73 ohms; key unchanged.
Question 21: answer and source
To transform any resistance at the termination of a transmission line to an impedance with magnitude equal to R of the line, the line length must be
Answer: L / 4
A quarter-wave (lambda/4) section inverts the load about the characteristic impedance; key unchanged.
Question 22: answer and source
In the radiated far field of a dipole antenna, electric and magnetic fields
Answer: Are in time phase
In the far field E and H are transverse and in time phase (ratio = intrinsic impedance); legacy keyed 'Both will not exist together'. Fixed misprint 'filed'.
Question 23: answer and source
The image frequency for a standard broadcast band receiver using 455 KHz IF and tuned to a station at 620 KHz is
Answer: 1530 KHz
Image frequency = fs + 2 IF = 620 + 910 = 1530 kHz; key unchanged.
Question 24: answer and source
The horizontal synchronising frequency in the TV receiver is
Answer: 15625 Hz
CCIR line frequency is 15,625 Hz (15,750 Hz is the FCC/NTSC value); key unchanged.
Question 25: answer and source
Under 100% amplitude modulation of a 10 KW carrier power, the total power required is
Answer: 15 KW
Pt = Pc(1 + m^2/2) = 10 x 1.5 = 15 kW; key unchanged.
Question 26: answer and source
Ionospheric propagation fails beyond the operating frequency of
Answer: 30,000 KHz
Above about 30 MHz (30,000 kHz) waves penetrate the ionosphere instead of being reflected; key unchanged.
Question 27: answer and source
Though the amount of noise is proportional to bandwidth, the wide band FM has high signal to noise ratio because
Answer: Limiter circuit is used in FM
The limiter strips amplitude noise before detection, giving FM its noise advantage; key unchanged. Fixed misprint 'Limited circuit'.
Question 28: answer and source
If the effective length of an antenna is increased, its directive gain
Answer: Increases
A longer antenna has a narrower main lobe and hence higher directive gain; legacy keyed 'Decreases'.
Question 29: answer and source
An antenna that is circularly polarised is
Answer: Helical
An axial-mode helical antenna radiates circular polarization; key unchanged.
Question 30: answer and source
Which of the following circuits does not require a coupling capacitor ?
Answer: Transformer Coupled
Transformer coupling transfers AC without a coupling capacitor; key unchanged. Fixed misprint 'Turned'.
Change log: 17 November 2026
Original question numbers and review decisions
- Original Q1: verified as keyed. Stability/decaying impulse response needs all poles in the left half of the s-plane; key unchanged. Fixed misprints 'apporaching'/'position'.
- Original Q2: verified as keyed. Ideal noise-free amplifier: noise factor F = 1, i.e. noise figure 0 dB; key unchanged.
- Original Q3: verified as keyed. The common-base stage is free of Miller-effect capacitance multiplication and is known for wider bandwidth than CE; legacy keyed 'Common Collector'.
- Original Q4: verified as keyed. The depletion region sits almost entirely in the semiconductor, so it is less on the metal side; key unchanged.
- Original Q5: verified as keyed. Negative feedback reduces internally generated noise by the same desensitivity factor (1 + AB) = K by which it reduces gain; legacy keyed 1/K.
- Original Q6: verified as keyed. Series mixing raises input impedance; current sampling raises output impedance; key unchanged.
- Original Q7: verified as keyed. Zener breakdown gives a stable reference voltage for regulation; key unchanged.
- Original Q8: verified as keyed. Saturation: both emitter and collector junctions are forward biased; key unchanged.
- Original Q9: verified as keyed. A current amplifier should take current in (low Rin) and drive current out (high Rout); key unchanged.
- Original Q10: verified as keyed. Icbo doubles about every 10 degrees C: 10 -> 20 -> 40 -> 80 microamps over 30 degrees; key unchanged.
- Original Q12: verified as keyed. Crystal oscillators have the highest Q and best frequency stability; key unchanged.
- Original Q13: verified as keyed. For a parallel resonant circuit Q = R/(omega L) (= omega C R); WL/R is the series-circuit form; legacy keyed WL/R. Fixed misprint 'paralled'.
- Original Q14: verified as keyed. A bootstrap sweep uses an emitter follower to feed the output back to the charging resistor; key unchanged.
- Original Q15: verified as keyed. M-derived half sections at the ends keep the image impedance nearly constant over the pass band; key unchanged.
- Original Q16: verified as keyed. Heaviside's distortionless condition: L/R = C/G, i.e. LG = RC; key unchanged.
- Original Q17: verified as keyed. The crystal's very high Q gives superior frequency stability; key unchanged.
- Original Q18: verified as keyed. A small standing bias (class AB) removes the dead zone that causes crossover distortion; key unchanged.
- Original Q19: verified as keyed. h-parameters mix impedance (h11), admittance (h22) and dimensionless ratios (h12, h21); key unchanged.
- Original Q20: verified as keyed. A wide band-pass is built by cascading a low-pass and a high-pass section; legacy keyed 'series tuned circuit'. Fixed misprint 'paralled'.
- Original Q21: verified as keyed. Half-wave dipole radiation resistance is about 73 ohms; key unchanged.
- Original Q22: verified as keyed. A quarter-wave (lambda/4) section inverts the load about the characteristic impedance; key unchanged.
- Original Q23: verified as keyed. In the far field E and H are transverse and in time phase (ratio = intrinsic impedance); legacy keyed 'Both will not exist together'. Fixed misprint 'filed'.
- Original Q24: verified as keyed. Image frequency = fs + 2 IF = 620 + 910 = 1530 kHz; key unchanged.
- Original Q25: verified as keyed. CCIR line frequency is 15,625 Hz (15,750 Hz is the FCC/NTSC value); key unchanged.
- Original Q26: verified as keyed. Pt = Pc(1 + m^2/2) = 10 x 1.5 = 15 kW; key unchanged.
- Original Q27: verified as keyed. Above about 30 MHz (30,000 kHz) waves penetrate the ionosphere instead of being reflected; key unchanged.
- Original Q28: verified as keyed. The limiter strips amplitude noise before detection, giving FM its noise advantage; key unchanged. Fixed misprint 'Limited circuit'.
- Original Q29: verified as keyed. A longer antenna has a narrower main lobe and hence higher directive gain; legacy keyed 'Decreases'.
- Original Q30: verified as keyed. An axial-mode helical antenna radiates circular polarization; key unchanged.
- Original Q31: verified as keyed. Transformer coupling transfers AC without a coupling capacitor; key unchanged. Fixed misprint 'Turned'.
- Original Q11: A matched (characteristic) load gives SWR = 1, which is not among the options; the remaining options (2/3, 1/2, 1/3) are physically impossible since SWR cannot be below 1. The option list looks like reflection-coefficient values copied by mistake. Dropped as unfixable.