Nível 6


30 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.

Insira os valores:
Resultados:
%

Answers and sources

Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.

Question 1: answer and source

In order to have the impulse response of a control system approaching zero with the time tending to infinity

Answer: The poles of the system must lie on the L.H.S of the S-plane

Stability/decaying impulse response needs all poles in the left half of the s-plane; key unchanged. Fixed misprints 'apporaching'/'position'.

Question 2: answer and source

For an ideal noise free amplifier, the noise figure is

Answer: Zero dB

Ideal noise-free amplifier: noise factor F = 1, i.e. noise figure 0 dB; key unchanged.

Question 3: answer and source

Wide bandwidth operation is offered by

Answer: Common Base Amplifier

The common-base stage is free of Miller-effect capacitance multiplication and is known for wider bandwidth than CE; legacy keyed 'Common Collector'.

Source 1

Question 4: answer and source

When a junction is formed between a metal and a semiconductor, the depletion layer is

Answer: Less on the side of the metal

The depletion region sits almost entirely in the semiconductor, so it is less on the metal side; key unchanged.

Question 5: answer and source

In the negative feedback amplifier with gain A / K, the noise generated in the amplifier is reduced by a factor of

Answer: K

Negative feedback reduces internally generated noise by the same desensitivity factor (1 + AB) = K by which it reduces gain; legacy keyed 1/K.

Question 6: answer and source

The type of negative feedback which results in the increase of both Zin and Zout of an amplifier is

Answer: Current-Series

Series mixing raises input impedance; current sampling raises output impedance; key unchanged.

Question 7: answer and source

Zener diodes are used in

Answer: Voltage Regulators

Zener breakdown gives a stable reference voltage for regulation; key unchanged.

Question 8: answer and source

In a saturated transistor

Answer: Both the junctions are forward biased

Saturation: both emitter and collector junctions are forward biased; key unchanged.

Question 9: answer and source

A good current amplifier has the following property

Answer: Low Rin and high Rout

A current amplifier should take current in (low Rin) and drive current out (high Rout); key unchanged.

Question 10: answer and source

A silicon transistor at a temperature of 25 Degrees C has leakage current Icbo of 10 microamps. If the temperature rises to 55 Degrees C the leakage current would be

Answer: 80 microamps

Icbo doubles about every 10 degrees C: 10 -> 20 -> 40 -> 80 microamps over 30 degrees; key unchanged.

Question 11: answer and source

The oscillator that has the best frequency stability is

Answer: Crystal Oscillator

Crystal oscillators have the highest Q and best frequency stability; key unchanged.

Question 12: answer and source

All the components in a parallel resonant circuit are ideal. The value of Q is

Answer: R / WL

For a parallel resonant circuit Q = R/(omega L) (= omega C R); WL/R is the series-circuit form; legacy keyed WL/R. Fixed misprint 'paralled'.

Question 13: answer and source

Bootstrap sweep circuit generally employs

Answer: Emitter Follower

A bootstrap sweep uses an emitter follower to feed the output back to the charging resistor; key unchanged.

Question 14: answer and source

In the design of composite filter, the end half m-derived section are included to

Answer: Realize constant value of characteristic impedance over operating frequency

M-derived half sections at the ends keep the image impedance nearly constant over the pass band; key unchanged.

Question 15: answer and source

The condition for a distortionless transmission line is

Answer: LG = RC

Heaviside's distortionless condition: L/R = C/G, i.e. LG = RC; key unchanged.

Question 16: answer and source

Crystal oscillators are preferred to LC oscillators due to their

Answer: Frequency Stability

The crystal's very high Q gives superior frequency stability; key unchanged.

Question 17: answer and source

In class B push pull amplifier, the cross-over distortion is eliminated by

Answer: Adopting class AB operation

A small standing bias (class AB) removes the dead zone that causes crossover distortion; key unchanged.

Question 18: answer and source

In the hybrid parameters representing the two port network, the parameters represent

Answer: Combination of the above

h-parameters mix impedance (h11), admittance (h22) and dimensionless ratios (h12, h21); key unchanged.

Question 19: answer and source

A band pass filter is usually designed as follows

Answer: Low pass filter followed by a high pass filter

A wide band-pass is built by cascading a low-pass and a high-pass section; legacy keyed 'series tuned circuit'. Fixed misprint 'paralled'.

Source 1

Question 20: answer and source

The radiation resistance of a half wave dipole antenna in free space

Answer: 73 Ohms

Half-wave dipole radiation resistance is about 73 ohms; key unchanged.

Question 21: answer and source

To transform any resistance at the termination of a transmission line to an impedance with magnitude equal to R of the line, the line length must be

Answer: L / 4

A quarter-wave (lambda/4) section inverts the load about the characteristic impedance; key unchanged.

Question 22: answer and source

In the radiated far field of a dipole antenna, electric and magnetic fields

Answer: Are in time phase

In the far field E and H are transverse and in time phase (ratio = intrinsic impedance); legacy keyed 'Both will not exist together'. Fixed misprint 'filed'.

Question 23: answer and source

The image frequency for a standard broadcast band receiver using 455 KHz IF and tuned to a station at 620 KHz is

Answer: 1530 KHz

Image frequency = fs + 2 IF = 620 + 910 = 1530 kHz; key unchanged.

Question 24: answer and source

The horizontal synchronising frequency in the TV receiver is

Answer: 15625 Hz

CCIR line frequency is 15,625 Hz (15,750 Hz is the FCC/NTSC value); key unchanged.

Source 1

Question 25: answer and source

Under 100% amplitude modulation of a 10 KW carrier power, the total power required is

Answer: 15 KW

Pt = Pc(1 + m^2/2) = 10 x 1.5 = 15 kW; key unchanged.

Question 26: answer and source

Ionospheric propagation fails beyond the operating frequency of

Answer: 30,000 KHz

Above about 30 MHz (30,000 kHz) waves penetrate the ionosphere instead of being reflected; key unchanged.

Question 27: answer and source

Though the amount of noise is proportional to bandwidth, the wide band FM has high signal to noise ratio because

Answer: Limiter circuit is used in FM

The limiter strips amplitude noise before detection, giving FM its noise advantage; key unchanged. Fixed misprint 'Limited circuit'.

Question 28: answer and source

If the effective length of an antenna is increased, its directive gain

Answer: Increases

A longer antenna has a narrower main lobe and hence higher directive gain; legacy keyed 'Decreases'.

Question 29: answer and source

An antenna that is circularly polarised is

Answer: Helical

An axial-mode helical antenna radiates circular polarization; key unchanged.

Question 30: answer and source

Which of the following circuits does not require a coupling capacitor ?

Answer: Transformer Coupled

Transformer coupling transfers AC without a coupling capacitor; key unchanged. Fixed misprint 'Turned'.

Change log: 17 November 2026

Original question numbers and review decisions
  • Original Q1: verified as keyed. Stability/decaying impulse response needs all poles in the left half of the s-plane; key unchanged. Fixed misprints 'apporaching'/'position'.
  • Original Q2: verified as keyed. Ideal noise-free amplifier: noise factor F = 1, i.e. noise figure 0 dB; key unchanged.
  • Original Q3: verified as keyed. The common-base stage is free of Miller-effect capacitance multiplication and is known for wider bandwidth than CE; legacy keyed 'Common Collector'.
  • Original Q4: verified as keyed. The depletion region sits almost entirely in the semiconductor, so it is less on the metal side; key unchanged.
  • Original Q5: verified as keyed. Negative feedback reduces internally generated noise by the same desensitivity factor (1 + AB) = K by which it reduces gain; legacy keyed 1/K.
  • Original Q6: verified as keyed. Series mixing raises input impedance; current sampling raises output impedance; key unchanged.
  • Original Q7: verified as keyed. Zener breakdown gives a stable reference voltage for regulation; key unchanged.
  • Original Q8: verified as keyed. Saturation: both emitter and collector junctions are forward biased; key unchanged.
  • Original Q9: verified as keyed. A current amplifier should take current in (low Rin) and drive current out (high Rout); key unchanged.
  • Original Q10: verified as keyed. Icbo doubles about every 10 degrees C: 10 -> 20 -> 40 -> 80 microamps over 30 degrees; key unchanged.
  • Original Q12: verified as keyed. Crystal oscillators have the highest Q and best frequency stability; key unchanged.
  • Original Q13: verified as keyed. For a parallel resonant circuit Q = R/(omega L) (= omega C R); WL/R is the series-circuit form; legacy keyed WL/R. Fixed misprint 'paralled'.
  • Original Q14: verified as keyed. A bootstrap sweep uses an emitter follower to feed the output back to the charging resistor; key unchanged.
  • Original Q15: verified as keyed. M-derived half sections at the ends keep the image impedance nearly constant over the pass band; key unchanged.
  • Original Q16: verified as keyed. Heaviside's distortionless condition: L/R = C/G, i.e. LG = RC; key unchanged.
  • Original Q17: verified as keyed. The crystal's very high Q gives superior frequency stability; key unchanged.
  • Original Q18: verified as keyed. A small standing bias (class AB) removes the dead zone that causes crossover distortion; key unchanged.
  • Original Q19: verified as keyed. h-parameters mix impedance (h11), admittance (h22) and dimensionless ratios (h12, h21); key unchanged.
  • Original Q20: verified as keyed. A wide band-pass is built by cascading a low-pass and a high-pass section; legacy keyed 'series tuned circuit'. Fixed misprint 'paralled'.
  • Original Q21: verified as keyed. Half-wave dipole radiation resistance is about 73 ohms; key unchanged.
  • Original Q22: verified as keyed. A quarter-wave (lambda/4) section inverts the load about the characteristic impedance; key unchanged.
  • Original Q23: verified as keyed. In the far field E and H are transverse and in time phase (ratio = intrinsic impedance); legacy keyed 'Both will not exist together'. Fixed misprint 'filed'.
  • Original Q24: verified as keyed. Image frequency = fs + 2 IF = 620 + 910 = 1530 kHz; key unchanged.
  • Original Q25: verified as keyed. CCIR line frequency is 15,625 Hz (15,750 Hz is the FCC/NTSC value); key unchanged.
  • Original Q26: verified as keyed. Pt = Pc(1 + m^2/2) = 10 x 1.5 = 15 kW; key unchanged.
  • Original Q27: verified as keyed. Above about 30 MHz (30,000 kHz) waves penetrate the ionosphere instead of being reflected; key unchanged.
  • Original Q28: verified as keyed. The limiter strips amplitude noise before detection, giving FM its noise advantage; key unchanged. Fixed misprint 'Limited circuit'.
  • Original Q29: verified as keyed. A longer antenna has a narrower main lobe and hence higher directive gain; legacy keyed 'Decreases'.
  • Original Q30: verified as keyed. An axial-mode helical antenna radiates circular polarization; key unchanged.
  • Original Q31: verified as keyed. Transformer coupling transfers AC without a coupling capacitor; key unchanged. Fixed misprint 'Turned'.
  • Original Q11: A matched (characteristic) load gives SWR = 1, which is not among the options; the remaining options (2/3, 1/2, 1/3) are physically impossible since SWR cannot be below 1. The option list looks like reflection-coefficient values copied by mistake. Dropped as unfixable.