Spinta-trazione di un cilindro inclinato
Ideal axial force = pressure difference × piston area, or annular area on the rod side.
Ideal axial force = pressure difference × piston area, or annular area on the rod side. The requested projected component is F sin θ: θ is measured between the cylinder axis and the load plane, so 0° gives zero and 90° gives the full axial force. If your angle is measured from the force direction, use its complement. Friction, seal losses, back-pressure differences and linkage geometry are not included. lbf and kgf are force units, not mass.
About this calculator
Ideal axial force = pressure difference × piston area, or annular area on the rod side. The requested projected component is F sin θ: θ is measured between the cylinder axis and the load plane, so 0° gives zero and 90° gives the full axial force. If your angle is measured from the force direction, use its complement. Friction, seal losses, back-pressure differences and linkage geometry are not included. lbf and kgf are force units, not mass.
What you need
- Cylinder bore diameter; the unit box converts between m, cm, mm, in, ft.
- Rod diameter; the unit box converts between m, cm, mm, in, ft (minimum 0).
- Pressure difference across piston; the unit box converts between Pa, kPa, MPa, GPa, psi (minimum 0).
- Angle to load plane in degrees (minimum 0).
Formula
Ideal axial push = p*pi*D^2/4.
Ideal axial pull = p*pi*(D^2-d^2)/4.
Projected push = pushAxial*sin(theta*pi/180).
Worked example
With cylinder bore diameter 2 m, rod diameter 2 m, pressure difference across piston 100 Pa, angle to load plane 10 degrees in Ideal projected cylinder force mode, the calculator gives ideal axial push = 314.1593 N; ideal axial pull = 0 N.
How to read the result
The main result is the ideal axial push, shown after you click Calculate; the copy button next to it copies the value. Additional results: ideal axial pull, projected push, projected pull.