Poussée-traction d'un vérin en angle


Ideal axial force = pressure difference × piston area, or annular area on the rod side.

Ideal axial force = pressure difference × piston area, or annular area on the rod side. The requested projected component is F sin θ: θ is measured between the cylinder axis and the load plane, so 0° gives zero and 90° gives the full axial force. If your angle is measured from the force direction, use its complement. Friction, seal losses, back-pressure differences and linkage geometry are not included. lbf and kgf are force units, not mass.

Saisissez vos valeurs :
degrees
Résultats :

About this calculator

Ideal axial force = pressure difference × piston area, or annular area on the rod side. The requested projected component is F sin θ: θ is measured between the cylinder axis and the load plane, so 0° gives zero and 90° gives the full axial force. If your angle is measured from the force direction, use its complement. Friction, seal losses, back-pressure differences and linkage geometry are not included. lbf and kgf are force units, not mass.

What you need

  • Cylinder bore diameter; the unit box converts between m, cm, mm, in, ft.
  • Rod diameter; the unit box converts between m, cm, mm, in, ft (minimum 0).
  • Pressure difference across piston; the unit box converts between Pa, kPa, MPa, GPa, psi (minimum 0).
  • Angle to load plane in degrees (minimum 0).

Formula

Ideal axial push = p*pi*D^2/4.

Ideal axial pull = p*pi*(D^2-d^2)/4.

Projected push = pushAxial*sin(theta*pi/180).

Worked example

With cylinder bore diameter 2 m, rod diameter 2 m, pressure difference across piston 100 Pa, angle to load plane 10 degrees in Ideal projected cylinder force mode, the calculator gives ideal axial push = 314.1593 N; ideal axial pull = 0 N.

How to read the result

The main result is the ideal axial push, shown after you click Calculate; the copy button next to it copies the value. Additional results: ideal axial pull, projected push, projected pull.