밀링 가공
Original milling travel estimates, with all lengths made explicit and converted consistently to mm.
Original milling travel estimates, with all lengths made explicit and converted consistently to mm. Peripheral approach = √(Dd−d²), using 5 mm assumed over-run. Facing over-run = [D−√(D²−w²)]/2 for D≥w; for D<w the original assumptions are approach D/2 and over-run 7 mm. For D≥w no separate facing approach is specified here: zero is a placeholder, not a required machine setup. Enter the actual approach and over-run explicitly in the time mode. Feed/rev = feed/tooth × teeth; single-cut time uses tooth feed × teeth × rpm, whereas total time uses the separately entered table feed. These feeds should agree for a consistent setup. Estimates exclude tool changes, handling, acceleration and return travel.
About this calculator
Original milling travel estimates, with all lengths made explicit and converted consistently to mm. Peripheral approach = √(Dd−d²), using 5 mm assumed over-run. Facing over-run = [D−√(D²−w²)]/2 for D≥w; for D<w the original assumptions are approach D/2 and over-run 7 mm. For D≥w no separate facing approach is specified here: zero is a placeholder, not a required machine setup. Enter the actual approach and over-run explicitly in the time mode. Feed/rev = feed/tooth × teeth; single-cut time uses tooth feed × teeth × rpm, whereas total time uses the separately entered table feed. These feeds should agree for a consistent setup. Estimates exclude tool changes, handling, acceleration and return travel.
It has 3 modes: Peripheral-cut approach, Facing over-run, Milling travel and time. Pick the tab for the quantity you want.
What you need
- Cutter diameter; the unit box converts between mm, cm, m, in.
- Depth of cut; the unit box converts between mm, cm, m, in (minimum 0).
Formula
Approach length = sqrt(D*d-d^2).
Assumed over-run = 5.
Worked example
With cutter diameter 2 mm, depth of cut 10 mm in Peripheral-cut approach mode, the calculator gives assumed over-run = 5 mm.
How to read the result
The main result is the approach length, shown after you click Calculate; the copy button next to it copies the value. Additional results: assumed over-run.