外圆磨削


Original estimating assumptions.

Original estimating assumptions: over-travel = 0.5 cm; roughing feed = wheel width/2 per revolution; finishing feed = wheel width/4 per revolution. Time = (job length + over-travel)/(feed per revolution × workpiece rpm). These are single-traverse estimates, not full machining cycles or process recommendations.

请输入数值:
rev/min
结果:
min
min

About this calculator

Original estimating assumptions: over-travel = 0.5 cm; roughing feed = wheel width/2 per revolution; finishing feed = wheel width/4 per revolution. Time = (job length + over-travel)/(feed per revolution × workpiece rpm). These are single-traverse estimates, not full machining cycles or process recommendations.

What you need

  • Job length; the unit box converts between cm, mm, in.
  • Grinding wheel width; the unit box converts between cm, mm, in.
  • Workpiece rotational speed in rev/min.

Formula

Length of cut = L+0.5.

Roughing feed per revolution = w/2.

Finishing feed per revolution = w/4.

Worked example

With job length 2 cm, grinding wheel width 2 cm, workpiece rotational speed 10 rev/min in Rough and finish traverse times mode, the calculator gives length of cut = 2.5 cm; roughing feed per revolution = 1 cm/rev; finishing feed per revolution = 0.5 cm/rev; roughing traverse time = 0.25 min; finishing traverse time = 0.5 min.

How to read the result

The main result is the length of cut, shown after you click Calculate; the copy button next to it copies the value. Additional results: roughing feed per revolution, finishing feed per revolution, roughing traverse time.