Rettifica cilindrica
Original estimating assumptions.
Original estimating assumptions: over-travel = 0.5 cm; roughing feed = wheel width/2 per revolution; finishing feed = wheel width/4 per revolution. Time = (job length + over-travel)/(feed per revolution × workpiece rpm). These are single-traverse estimates, not full machining cycles or process recommendations.
About this calculator
Original estimating assumptions: over-travel = 0.5 cm; roughing feed = wheel width/2 per revolution; finishing feed = wheel width/4 per revolution. Time = (job length + over-travel)/(feed per revolution × workpiece rpm). These are single-traverse estimates, not full machining cycles or process recommendations.
What you need
- Job length; the unit box converts between cm, mm, in.
- Grinding wheel width; the unit box converts between cm, mm, in.
- Workpiece rotational speed in rev/min.
Formula
Length of cut = L+0.5.
Roughing feed per revolution = w/2.
Finishing feed per revolution = w/4.
Worked example
With job length 2 cm, grinding wheel width 2 cm, workpiece rotational speed 10 rev/min in Rough and finish traverse times mode, the calculator gives length of cut = 2.5 cm; roughing feed per revolution = 1 cm/rev; finishing feed per revolution = 0.5 cm/rev; roughing traverse time = 0.25 min; finishing traverse time = 0.5 min.
How to read the result
The main result is the length of cut, shown after you click Calculate; the copy button next to it copies the value. Additional results: roughing feed per revolution, finishing feed per revolution, roughing traverse time.