المستوى 8


31 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.

أدخل القيم:
النتائج:
%

Answers and sources

Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.

Question 1: answer and source

The typical squelch circuit

Answer: Cuts off an audio amplifier when the carrier is absent

Squelch mutes the audio when no carrier is received; key unchanged.

Question 2: answer and source

For a signal amplitude modulated to a depth of 100% by sinusoidal signal, what is the power ?

Answer: 3/2 times the power of unmodulated carrier

Pt = Pc(1 + m^2/2) = 1.5 Pc at m = 1; key unchanged.

Question 3: answer and source

In FM, the frequency deviation is generally

Answer: Proportional to amplitude of modulating signal

Deviation is proportional to the modulating amplitude only; key unchanged.

Question 4: answer and source

Audio frequency range lie between

Answer: 20 Hz and 20 KHz

The audio band is 20 Hz to 20 kHz; key unchanged.

Question 5: answer and source

Maximum undistorted power output of a transmitter can be expected when its modulation is

Answer: 100 %

100% modulation gives the most sideband power without over-modulation distortion; key unchanged.

Question 6: answer and source

An FM signal with a deviation a is passed through a mixer, and has its frequency reduced six fold. The deviation in the output of the mixer will be equal to

Answer: a

A mixer translates frequency without changing deviation (only multipliers scale deviation); key unchanged.

Question 7: answer and source

What is the unit of modulation index

Answer: No unit

Modulation index is a ratio, hence dimensionless; key unchanged.

Question 8: answer and source

In the stabilized reactance modulator AFC system

Answer: The discriminator must have a time constant to prevent demodulation

The discriminator diode load has a large time constant (about 100 ms) so it responds to slow drift but not to the modulation itself; legacy keyed option C.

Source 1

Question 9: answer and source

The percentage saving in power of 100% modulated suppressed carrier AM signal is

Answer: 66 2/3

Carrier is Pc out of 1.5 Pc total at m = 1, so suppressing it saves 66.7%; key unchanged.

Question 10: answer and source

The maximum I or V on the modulated carrier wave is 5 units and minimum is 3 units. The percentage of modulation will be equal to

Answer: 25

m = (Emax - Emin)/(Emax + Emin) = 2/8 = 25%; key unchanged.

Question 11: answer and source

An oscillator at 4.2 MHz is followed by two frequency doublers and two triplers. The output frequency will be

Answer: 151.2 MHz

4.2 x 2 x 2 x 3 x 3 = 151.2 MHz; key unchanged. Fixed misprint 'ouput'.

Question 12: answer and source

Tuned voltage amplifiers are not used

Answer: In public address system

PA systems are wideband audio and use untuned amplifiers; key unchanged.

Question 13: answer and source

A3A modulation is sometimes used to

Answer: Simplify the frequency stability problem in reception

A3A (SSB with reduced carrier) keeps a pilot carrier as a reference, easing receiver frequency-stability requirements; key unchanged.

Question 14: answer and source

The final power amplifier in an FM transmitter generally operates as

Answer: Class C

FM has constant envelope, so efficient class C is used; key unchanged.

Question 15: answer and source

Quantizing noise takes place in

Answer: PCM

Quantizing noise arises from the amplitude quantization in PCM; legacy keyed PPM.

Question 16: answer and source

A pre-emphasis circuit provides extra noise immunity by

Answer: Amplifying the higher audio frequencies

Pre-emphasis boosts high audio frequencies where noise hurts most; key unchanged.

Question 17: answer and source

If all three elements of a given Delta-connected network are pure inductive reactance, the three elements of the corresponding star connected network

Answer: Will all be pure inductive reactances

Delta-star transformation of equal inductors gives inductors of one-third the value; key unchanged.

Question 18: answer and source

Which of the following laws of electrical network is used in the node voltage analysis of the networks ?

Answer: Kirchoff's Current Law

Nodal analysis applies KCL at each node; key unchanged.

Question 19: answer and source

A sinusoidal waveform is mathematically represented by

Answer: An Odd Function

sin(-x) = -sin(x): an odd function; key unchanged.

Question 20: answer and source

The trigonometric fourier series expansion of an even function that is also half-wave symmetric shall contain

Answer: Only odd harmonics of cosine terms

Even -> cosine terms only; half-wave symmetry -> odd harmonics only; key unchanged.

Question 21: answer and source

If a synchronous converter is supplied with 12 phase A.C supply, the number of slip rings will be

Answer: 12

A synchronous converter has one slip ring per supply phase; key unchanged.

Question 22: answer and source

When a rotor converter is started by means of a small auxiliary motor, the power of motor, must be

Answer: Slightly more than the value of friction and windage losses at rated speed

The pony motor only has to spin the unloaded converter, so it needs to cover friction and windage only; key unchanged.

Question 23: answer and source

Maximum current rating of a glass bulb mercury arc rectifier is usually restricted to

Answer: 500 A

Glass-bulb mercury arc rectifiers were limited to about 500 A (steel tanks for higher); key unchanged.

Question 24: answer and source

In a arc rectifier the drop in voltage at the cathode is approximately

Answer: 6 to 7 Volts

The cathode spot drop of a mercury arc is about 6-7 V; key unchanged.

Question 25: answer and source

In a mercury arc rectifier the cathode voltage drop is because of

Answer: Expenditure of energy in liberating electrons from mercury

The cathode drop is the work spent liberating electrons from the mercury surface; key unchanged. Fixed misprint 'librating'.

Question 26: answer and source

The average life of the glass bulb rectifier is

Answer: 10,000 to 15,000 Hours

Glass-bulb mercury arc rectifiers typically lasted 10,000-15,000 hours; key unchanged.

Question 27: answer and source

The vacuum inside the glass bulb of a mercury arc rectifier is of the order of

Answer: 5 x 10^-5 cm of Hg

The bulb vacuum is of the order of 5 x 10^-5 cm of Hg; key unchanged.

Question 28: answer and source

A 3 anode mercury arc rectifier has an anode current of overlap 30 degrees. Neglecting arc drop, the regulation will be approximately

Answer: 7%

Overlap reduces the mean output by (1 - cos u)/2 = (1 - 0.866)/2 = 6.7%, about 7%; legacy keyed 9%. Fixed misprint 'overlap 300' (degree symbol lost).

Question 29: answer and source

Which of the following is the loss within the mercury arc rectifier chamber

Answer: All of the above

Cathode drop, anode drop and arc drop all dissipate power inside the chamber; key unchanged.

Question 30: answer and source

For single phase supply frequency of 50 Hz, ripple frequency in full wave rectifier is

Answer: 100

Full-wave rectification doubles the ripple frequency: 2 x 50 = 100 Hz; key unchanged. Fixed misprint '5 Hz' -> '50 Hz'.

Question 31: answer and source

As compared to a CB amplifier, a CE amplifier has

Answer: Higher Current Amplification

CE current gain (beta) far exceeds CB current gain (alpha < 1); key unchanged.

Change log: 17 November 2026

Original question numbers and review decisions
  • Original Q1: verified as keyed. Squelch mutes the audio when no carrier is received; key unchanged.
  • Original Q2: verified as keyed. Pt = Pc(1 + m^2/2) = 1.5 Pc at m = 1; key unchanged.
  • Original Q3: verified as keyed. Deviation is proportional to the modulating amplitude only; key unchanged.
  • Original Q4: verified as keyed. The audio band is 20 Hz to 20 kHz; key unchanged.
  • Original Q5: verified as keyed. 100% modulation gives the most sideband power without over-modulation distortion; key unchanged.
  • Original Q6: verified as keyed. A mixer translates frequency without changing deviation (only multipliers scale deviation); key unchanged.
  • Original Q7: verified as keyed. Modulation index is a ratio, hence dimensionless; key unchanged.
  • Original Q8: verified as keyed. The discriminator diode load has a large time constant (about 100 ms) so it responds to slow drift but not to the modulation itself; legacy keyed option C.
  • Original Q9: verified as keyed. Carrier is Pc out of 1.5 Pc total at m = 1, so suppressing it saves 66.7%; key unchanged.
  • Original Q10: verified as keyed. m = (Emax - Emin)/(Emax + Emin) = 2/8 = 25%; key unchanged.
  • Original Q11: verified as keyed. 4.2 x 2 x 2 x 3 x 3 = 151.2 MHz; key unchanged. Fixed misprint 'ouput'.
  • Original Q12: verified as keyed. PA systems are wideband audio and use untuned amplifiers; key unchanged.
  • Original Q13: verified as keyed. A3A (SSB with reduced carrier) keeps a pilot carrier as a reference, easing receiver frequency-stability requirements; key unchanged.
  • Original Q14: verified as keyed. FM has constant envelope, so efficient class C is used; key unchanged.
  • Original Q15: verified as keyed. Quantizing noise arises from the amplitude quantization in PCM; legacy keyed PPM.
  • Original Q16: verified as keyed. Pre-emphasis boosts high audio frequencies where noise hurts most; key unchanged.
  • Original Q17: verified as keyed. Delta-star transformation of equal inductors gives inductors of one-third the value; key unchanged.
  • Original Q18: verified as keyed. Nodal analysis applies KCL at each node; key unchanged.
  • Original Q19: verified as keyed. sin(-x) = -sin(x): an odd function; key unchanged.
  • Original Q20: verified as keyed. Even -> cosine terms only; half-wave symmetry -> odd harmonics only; key unchanged.
  • Original Q21: verified as keyed. A synchronous converter has one slip ring per supply phase; key unchanged.
  • Original Q22: verified as keyed. The pony motor only has to spin the unloaded converter, so it needs to cover friction and windage only; key unchanged.
  • Original Q23: verified as keyed. Glass-bulb mercury arc rectifiers were limited to about 500 A (steel tanks for higher); key unchanged.
  • Original Q24: verified as keyed. The cathode spot drop of a mercury arc is about 6-7 V; key unchanged.
  • Original Q25: verified as keyed. The cathode drop is the work spent liberating electrons from the mercury surface; key unchanged. Fixed misprint 'librating'.
  • Original Q26: verified as keyed. Glass-bulb mercury arc rectifiers typically lasted 10,000-15,000 hours; key unchanged.
  • Original Q27: verified as keyed. The bulb vacuum is of the order of 5 x 10^-5 cm of Hg; key unchanged.
  • Original Q28: verified as keyed. Overlap reduces the mean output by (1 - cos u)/2 = (1 - 0.866)/2 = 6.7%, about 7%; legacy keyed 9%. Fixed misprint 'overlap 300' (degree symbol lost).
  • Original Q29: verified as keyed. Cathode drop, anode drop and arc drop all dissipate power inside the chamber; key unchanged.
  • Original Q30: verified as keyed. Full-wave rectification doubles the ripple frequency: 2 x 50 = 100 Hz; key unchanged. Fixed misprint '5 Hz' -> '50 Hz'.
  • Original Q31: verified as keyed. CE current gain (beta) far exceeds CB current gain (alpha < 1); key unchanged.