المستوى 4
30 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.
Answers and sources
Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.
Question 1: answer and source
An ideal power supply is characterized by
Answer: Zero internal resistance
An ideal voltage source has zero internal resistance; key unchanged.
Question 2: answer and source
Voice signal frequency lies between
Answer: 15 Hz -> 15 KHz
Classic texts quote the speech/audio range as about 15 Hz to 15 kHz; key unchanged.
Question 3: answer and source
A complex wave form made up frequency components 1 Hz, 3 Hz, 5 Hz, 7 Hz and 9 Hz. Its fundamental frequency is
Answer: 1 Hz
All components are harmonics of 1 Hz, so the fundamental is 1 Hz; key unchanged.
Question 4: answer and source
A sawtooth waveform is made up of
Answer: All odd and even harmonics
A sawtooth contains both odd and even harmonics; key unchanged.
Question 5: answer and source
A square wave form applied to a differentiator circuit gives positive and negative spikes. Is it true ?
Answer: Yes
The derivative of a square wave is zero except at the edges, where it gives alternating spikes; key unchanged.
Question 6: answer and source
Which of the following magnetic material has least value of B.H ?
Answer: Carbon Steel
Carbon steel is the weakest permanent-magnet material of the list (lowest energy product BH); key unchanged.
Question 7: answer and source
Transmission of a wave in a closed wave guide is possible only when
Answer: Phase-shift is real positive
A waveguide propagates only above its cutoff frequency, where the phase constant becomes real (below cutoff the wave is attenuated); legacy keyed 'frequency less than critical value', which is the no-propagation case.
Question 8: answer and source
An integrator circuit should have
Answer: Very large time constant
An RC integrator needs a time constant much larger than the input period; key unchanged. Fixed misprint 'intergrator'.
Question 9: answer and source
Standard Loran operates in which frequency range
Answer: 1.8 to 2 MHz
Standard LORAN (LORAN-A) operated in and around the 1.8-2 MHz (160 metre) band; legacy keyed 'None of these'. Fixed misprint 'Lorrn'.
Question 10: answer and source
In all Pulse Communication Systems, carrier
Answer: Is necessarily a high repetition rate train of pulses
In pulse communication systems the carrier is a train of pulses (PAM/PWM/PPM vary a pulse parameter); legacy keyed 'either a train of pulses or a continuous a.c. wave'.
Question 11: answer and source
In amplitude modulation
Answer: Separation of successive maximum and minimum of modulated envelope on time-axis is inversely proportional to the frequency of modulating signal.
The envelope varies at the modulating frequency fm, so the max-to-min time gap = 1/(2fm), inversely proportional to fm; legacy keyed option A. Typos cleaned.
Question 12: answer and source
In DSB system with carrier when the intelligence varies between 100 Hz to 5 KHz, bandwidth is
Answer: 10 KHz
DSB bandwidth = 2 x highest modulating frequency = 2 x 5 kHz = 10 kHz; legacy keyed 200 Hz.
Question 13: answer and source
Signal at the output of an AM modulator is given by e = 5.3 (1 + 0.64 sin 6280t) sin 10^6 t. Depth of modulation for it is
Answer: 64 %
The modulation index is the coefficient 0.64, i.e. 64%; legacy keyed 0.80%. Fixed misprint '106t' -> '10^6 t'.
Question 14: answer and source
In frequency modulation
Answer: Carrier frequency changes in accordance with the modulating signal amplitude
In FM the deviation is proportional to the modulating signal amplitude; the modulating frequency sets the rate of change, not the amount; legacy keyed option C.
Question 15: answer and source
Modulation index in FM is given by
Answer: None of these
mf = frequency deviation / modulating frequency, which none of A-C states (deviation/75 kHz is percentage modulation); legacy keyed option A.
Question 16: answer and source
Modulation index (mf) in FM is
Answer: Directly proportional to frequency deviation and inversely proportional to the modulating frequency.
mf = deviation / modulating frequency; key unchanged.
Question 17: answer and source
Polarization of an electromagnetic wave is
Answer: The direction of its electrical field component with respect to ground
Polarization is defined by the electric field orientation; key unchanged.
Question 18: answer and source
A TM wave is characterized by
Answer: The absence of magnetic component in the direction of propagation
Transverse Magnetic: the magnetic field has no component along the direction of propagation; key unchanged.
Question 19: answer and source
A TEM wave cannot exist within a hollow metallic pipe. It is true
Answer: Yes
A hollow single-conductor waveguide supports only TE/TM modes, never TEM; legacy keyed 'Not necessarily'.
Question 20: answer and source
Which is most commonly used transmission-line with television system ?
Answer: Coaxial Cable
Coaxial cable is the standard TV feeder; key unchanged.
Question 21: answer and source
A transmission line with characteristic impedance of 300 is used to interconnect receiving antenna and receiver input. A reflection coefficient of 1/3 is observed on the line. Receiver input impedance is equal to
Answer: 150
Gamma = (ZL - Z0)/(ZL + Z0) = -1/3 gives ZL = 150 ohms (the +1/3 case gives 600, not offered); key unchanged.
Question 22: answer and source
Ionization of various gases resulting in the formation of Ionosphere is because of
Answer: Radiations from the sun
Solar ultraviolet and X-ray radiation ionizes the upper atmosphere; legacy keyed 'Pressure variations with altitude'.
Question 23: answer and source
A modulated signal (AM) is having depth of modulation equal to 80%, then feeder current under modulated conditions is greater than that under unmodulated conditions by
Answer: 15%
It/Ic = sqrt(1 + m^2/2) = sqrt(1.32) = 1.149, about 15% greater; key unchanged.
Question 24: answer and source
Fidelity, in a communication receiver, is provided by
Answer: Audio Stage
Fidelity (faithful reproduction) is set by the audio stage's frequency response; key unchanged.
Question 25: answer and source
Video signals have a frequency range that is spread over approximately
Answer: 18 Octaves
Video spans from tens of Hz to about 4.5 MHz, roughly 18 octaves; legacy keyed 4 octaves.
Question 26: answer and source
Where is brightness control located in a TV ?
Answer: Grid-cathode circuit of picture tube
Brightness is set by varying the DC bias of the picture tube's grid-cathode circuit; legacy keyed 'Audio Section'.
Question 27: answer and source
Where is fine tuning control present in television receiver ?
Answer: A potentiometer
Fine tuning slightly varies the local oscillator frequency, commonly via a potentiometer adjusting a varactor diode (variable capacitors/inductors were also used); key unchanged. Fixed misprint 'condensor'.
Question 28: answer and source
Horizontal oscillator in a TV receiver generates a sawtooth signal of
Answer: 15,750 Hz in FCC Standards
FCC/NTSC line frequency is 15,750 Hz (CCIR is 15,625 Hz; 50/60 Hz are field rates); legacy keyed option D.
Question 29: answer and source
Television cameras A and B have tubes which are 3 inch and 4.5 inch long resp. When a lens of known length is used with the tubes, then
Answer: Angle of view of B is greater than that of A
For the same lens focal length, the larger image (target) size of the 4.5 inch tube covers a wider angle of view; legacy keyed 'None of these'.
Question 30: answer and source
Television screen width is always greater than the screen height or in other words raster width more than raster height because
Answer: Picture motion is in the horizontal direction
The 4:3 aspect ratio suits scenes whose action and the human field of view are predominantly horizontal; legacy keyed 'Horizontal deflection frequency is higher'. Fixed misprint 'rastar'.
Change log: 17 November 2026
Original question numbers and review decisions
- Original Q1: verified as keyed. An ideal voltage source has zero internal resistance; key unchanged.
- Original Q2: verified as keyed. Classic texts quote the speech/audio range as about 15 Hz to 15 kHz; key unchanged.
- Original Q3: verified as keyed. All components are harmonics of 1 Hz, so the fundamental is 1 Hz; key unchanged.
- Original Q4: verified as keyed. A sawtooth contains both odd and even harmonics; key unchanged.
- Original Q5: verified as keyed. The derivative of a square wave is zero except at the edges, where it gives alternating spikes; key unchanged.
- Original Q6: verified as keyed. Carbon steel is the weakest permanent-magnet material of the list (lowest energy product BH); key unchanged.
- Original Q7: verified as keyed. A waveguide propagates only above its cutoff frequency, where the phase constant becomes real (below cutoff the wave is attenuated); legacy keyed 'frequency less than critical value', which is the no-propagation case.
- Original Q8: verified as keyed. An RC integrator needs a time constant much larger than the input period; key unchanged. Fixed misprint 'intergrator'.
- Original Q9: verified as keyed. Standard LORAN (LORAN-A) operated in and around the 1.8-2 MHz (160 metre) band; legacy keyed 'None of these'. Fixed misprint 'Lorrn'.
- Original Q10: verified as keyed. In pulse communication systems the carrier is a train of pulses (PAM/PWM/PPM vary a pulse parameter); legacy keyed 'either a train of pulses or a continuous a.c. wave'.
- Original Q11: verified as keyed. The envelope varies at the modulating frequency fm, so the max-to-min time gap = 1/(2fm), inversely proportional to fm; legacy keyed option A. Typos cleaned.
- Original Q12: verified as keyed. DSB bandwidth = 2 x highest modulating frequency = 2 x 5 kHz = 10 kHz; legacy keyed 200 Hz.
- Original Q13: verified as keyed. The modulation index is the coefficient 0.64, i.e. 64%; legacy keyed 0.80%. Fixed misprint '106t' -> '10^6 t'.
- Original Q14: verified as keyed. In FM the deviation is proportional to the modulating signal amplitude; the modulating frequency sets the rate of change, not the amount; legacy keyed option C.
- Original Q15: verified as keyed. mf = frequency deviation / modulating frequency, which none of A-C states (deviation/75 kHz is percentage modulation); legacy keyed option A.
- Original Q16: verified as keyed. mf = deviation / modulating frequency; key unchanged.
- Original Q17: verified as keyed. Polarization is defined by the electric field orientation; key unchanged.
- Original Q18: verified as keyed. Transverse Magnetic: the magnetic field has no component along the direction of propagation; key unchanged.
- Original Q19: verified as keyed. A hollow single-conductor waveguide supports only TE/TM modes, never TEM; legacy keyed 'Not necessarily'.
- Original Q20: verified as keyed. Coaxial cable is the standard TV feeder; key unchanged.
- Original Q21: verified as keyed. Gamma = (ZL - Z0)/(ZL + Z0) = -1/3 gives ZL = 150 ohms (the +1/3 case gives 600, not offered); key unchanged.
- Original Q22: verified as keyed. Solar ultraviolet and X-ray radiation ionizes the upper atmosphere; legacy keyed 'Pressure variations with altitude'.
- Original Q23: verified as keyed. It/Ic = sqrt(1 + m^2/2) = sqrt(1.32) = 1.149, about 15% greater; key unchanged.
- Original Q24: verified as keyed. Fidelity (faithful reproduction) is set by the audio stage's frequency response; key unchanged.
- Original Q25: verified as keyed. Video spans from tens of Hz to about 4.5 MHz, roughly 18 octaves; legacy keyed 4 octaves.
- Original Q26: verified as keyed. Brightness is set by varying the DC bias of the picture tube's grid-cathode circuit; legacy keyed 'Audio Section'.
- Original Q27: verified as keyed. Fine tuning slightly varies the local oscillator frequency, commonly via a potentiometer adjusting a varactor diode (variable capacitors/inductors were also used); key unchanged. Fixed misprint 'condensor'.
- Original Q28: verified as keyed. FCC/NTSC line frequency is 15,750 Hz (CCIR is 15,625 Hz; 50/60 Hz are field rates); legacy keyed option D.
- Original Q29: verified as keyed. For the same lens focal length, the larger image (target) size of the 4.5 inch tube covers a wider angle of view; legacy keyed 'None of these'.
- Original Q30: verified as keyed. The 4:3 aspect ratio suits scenes whose action and the human field of view are predominantly horizontal; legacy keyed 'Horizontal deflection frequency is higher'. Fixed misprint 'rastar'.
- Original Q31: Legacy options were 'Base / AB / B / C' - the option list is mangled beyond repair (a PNP transistor has base, emitter and collector regions), so no defensible answer can be constructed. Dropped as unfixable.