レベル 4


30 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.

数値を入力:
計算結果:
%

Answers and sources

Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.

Question 1: answer and source

An ideal power supply is characterized by

Answer: Zero internal resistance

An ideal voltage source has zero internal resistance; key unchanged.

Question 2: answer and source

Voice signal frequency lies between

Answer: 15 Hz -> 15 KHz

Classic texts quote the speech/audio range as about 15 Hz to 15 kHz; key unchanged.

Question 3: answer and source

A complex wave form made up frequency components 1 Hz, 3 Hz, 5 Hz, 7 Hz and 9 Hz. Its fundamental frequency is

Answer: 1 Hz

All components are harmonics of 1 Hz, so the fundamental is 1 Hz; key unchanged.

Question 4: answer and source

A sawtooth waveform is made up of

Answer: All odd and even harmonics

A sawtooth contains both odd and even harmonics; key unchanged.

Question 5: answer and source

A square wave form applied to a differentiator circuit gives positive and negative spikes. Is it true ?

Answer: Yes

The derivative of a square wave is zero except at the edges, where it gives alternating spikes; key unchanged.

Question 6: answer and source

Which of the following magnetic material has least value of B.H ?

Answer: Carbon Steel

Carbon steel is the weakest permanent-magnet material of the list (lowest energy product BH); key unchanged.

Question 7: answer and source

Transmission of a wave in a closed wave guide is possible only when

Answer: Phase-shift is real positive

A waveguide propagates only above its cutoff frequency, where the phase constant becomes real (below cutoff the wave is attenuated); legacy keyed 'frequency less than critical value', which is the no-propagation case.

Question 8: answer and source

An integrator circuit should have

Answer: Very large time constant

An RC integrator needs a time constant much larger than the input period; key unchanged. Fixed misprint 'intergrator'.

Question 9: answer and source

Standard Loran operates in which frequency range

Answer: 1.8 to 2 MHz

Standard LORAN (LORAN-A) operated in and around the 1.8-2 MHz (160 metre) band; legacy keyed 'None of these'. Fixed misprint 'Lorrn'.

Source 1

Question 10: answer and source

In all Pulse Communication Systems, carrier

Answer: Is necessarily a high repetition rate train of pulses

In pulse communication systems the carrier is a train of pulses (PAM/PWM/PPM vary a pulse parameter); legacy keyed 'either a train of pulses or a continuous a.c. wave'.

Source 1

Question 11: answer and source

In amplitude modulation

Answer: Separation of successive maximum and minimum of modulated envelope on time-axis is inversely proportional to the frequency of modulating signal.

The envelope varies at the modulating frequency fm, so the max-to-min time gap = 1/(2fm), inversely proportional to fm; legacy keyed option A. Typos cleaned.

Question 12: answer and source

In DSB system with carrier when the intelligence varies between 100 Hz to 5 KHz, bandwidth is

Answer: 10 KHz

DSB bandwidth = 2 x highest modulating frequency = 2 x 5 kHz = 10 kHz; legacy keyed 200 Hz.

Question 13: answer and source

Signal at the output of an AM modulator is given by e = 5.3 (1 + 0.64 sin 6280t) sin 10^6 t. Depth of modulation for it is

Answer: 64 %

The modulation index is the coefficient 0.64, i.e. 64%; legacy keyed 0.80%. Fixed misprint '106t' -> '10^6 t'.

Question 14: answer and source

In frequency modulation

Answer: Carrier frequency changes in accordance with the modulating signal amplitude

In FM the deviation is proportional to the modulating signal amplitude; the modulating frequency sets the rate of change, not the amount; legacy keyed option C.

Question 15: answer and source

Modulation index in FM is given by

Answer: None of these

mf = frequency deviation / modulating frequency, which none of A-C states (deviation/75 kHz is percentage modulation); legacy keyed option A.

Question 16: answer and source

Modulation index (mf) in FM is

Answer: Directly proportional to frequency deviation and inversely proportional to the modulating frequency.

mf = deviation / modulating frequency; key unchanged.

Question 17: answer and source

Polarization of an electromagnetic wave is

Answer: The direction of its electrical field component with respect to ground

Polarization is defined by the electric field orientation; key unchanged.

Question 18: answer and source

A TM wave is characterized by

Answer: The absence of magnetic component in the direction of propagation

Transverse Magnetic: the magnetic field has no component along the direction of propagation; key unchanged.

Question 19: answer and source

A TEM wave cannot exist within a hollow metallic pipe. It is true

Answer: Yes

A hollow single-conductor waveguide supports only TE/TM modes, never TEM; legacy keyed 'Not necessarily'.

Question 20: answer and source

Which is most commonly used transmission-line with television system ?

Answer: Coaxial Cable

Coaxial cable is the standard TV feeder; key unchanged.

Question 21: answer and source

A transmission line with characteristic impedance of 300 is used to interconnect receiving antenna and receiver input. A reflection coefficient of 1/3 is observed on the line. Receiver input impedance is equal to

Answer: 150

Gamma = (ZL - Z0)/(ZL + Z0) = -1/3 gives ZL = 150 ohms (the +1/3 case gives 600, not offered); key unchanged.

Question 22: answer and source

Ionization of various gases resulting in the formation of Ionosphere is because of

Answer: Radiations from the sun

Solar ultraviolet and X-ray radiation ionizes the upper atmosphere; legacy keyed 'Pressure variations with altitude'.

Question 23: answer and source

A modulated signal (AM) is having depth of modulation equal to 80%, then feeder current under modulated conditions is greater than that under unmodulated conditions by

Answer: 15%

It/Ic = sqrt(1 + m^2/2) = sqrt(1.32) = 1.149, about 15% greater; key unchanged.

Question 24: answer and source

Fidelity, in a communication receiver, is provided by

Answer: Audio Stage

Fidelity (faithful reproduction) is set by the audio stage's frequency response; key unchanged.

Question 25: answer and source

Video signals have a frequency range that is spread over approximately

Answer: 18 Octaves

Video spans from tens of Hz to about 4.5 MHz, roughly 18 octaves; legacy keyed 4 octaves.

Source 1

Question 26: answer and source

Where is brightness control located in a TV ?

Answer: Grid-cathode circuit of picture tube

Brightness is set by varying the DC bias of the picture tube's grid-cathode circuit; legacy keyed 'Audio Section'.

Source 1

Question 27: answer and source

Where is fine tuning control present in television receiver ?

Answer: A potentiometer

Fine tuning slightly varies the local oscillator frequency, commonly via a potentiometer adjusting a varactor diode (variable capacitors/inductors were also used); key unchanged. Fixed misprint 'condensor'.

Source 1

Question 28: answer and source

Horizontal oscillator in a TV receiver generates a sawtooth signal of

Answer: 15,750 Hz in FCC Standards

FCC/NTSC line frequency is 15,750 Hz (CCIR is 15,625 Hz; 50/60 Hz are field rates); legacy keyed option D.

Source 1

Question 29: answer and source

Television cameras A and B have tubes which are 3 inch and 4.5 inch long resp. When a lens of known length is used with the tubes, then

Answer: Angle of view of B is greater than that of A

For the same lens focal length, the larger image (target) size of the 4.5 inch tube covers a wider angle of view; legacy keyed 'None of these'.

Question 30: answer and source

Television screen width is always greater than the screen height or in other words raster width more than raster height because

Answer: Picture motion is in the horizontal direction

The 4:3 aspect ratio suits scenes whose action and the human field of view are predominantly horizontal; legacy keyed 'Horizontal deflection frequency is higher'. Fixed misprint 'rastar'.

Change log: 17 November 2026

Original question numbers and review decisions
  • Original Q1: verified as keyed. An ideal voltage source has zero internal resistance; key unchanged.
  • Original Q2: verified as keyed. Classic texts quote the speech/audio range as about 15 Hz to 15 kHz; key unchanged.
  • Original Q3: verified as keyed. All components are harmonics of 1 Hz, so the fundamental is 1 Hz; key unchanged.
  • Original Q4: verified as keyed. A sawtooth contains both odd and even harmonics; key unchanged.
  • Original Q5: verified as keyed. The derivative of a square wave is zero except at the edges, where it gives alternating spikes; key unchanged.
  • Original Q6: verified as keyed. Carbon steel is the weakest permanent-magnet material of the list (lowest energy product BH); key unchanged.
  • Original Q7: verified as keyed. A waveguide propagates only above its cutoff frequency, where the phase constant becomes real (below cutoff the wave is attenuated); legacy keyed 'frequency less than critical value', which is the no-propagation case.
  • Original Q8: verified as keyed. An RC integrator needs a time constant much larger than the input period; key unchanged. Fixed misprint 'intergrator'.
  • Original Q9: verified as keyed. Standard LORAN (LORAN-A) operated in and around the 1.8-2 MHz (160 metre) band; legacy keyed 'None of these'. Fixed misprint 'Lorrn'.
  • Original Q10: verified as keyed. In pulse communication systems the carrier is a train of pulses (PAM/PWM/PPM vary a pulse parameter); legacy keyed 'either a train of pulses or a continuous a.c. wave'.
  • Original Q11: verified as keyed. The envelope varies at the modulating frequency fm, so the max-to-min time gap = 1/(2fm), inversely proportional to fm; legacy keyed option A. Typos cleaned.
  • Original Q12: verified as keyed. DSB bandwidth = 2 x highest modulating frequency = 2 x 5 kHz = 10 kHz; legacy keyed 200 Hz.
  • Original Q13: verified as keyed. The modulation index is the coefficient 0.64, i.e. 64%; legacy keyed 0.80%. Fixed misprint '106t' -> '10^6 t'.
  • Original Q14: verified as keyed. In FM the deviation is proportional to the modulating signal amplitude; the modulating frequency sets the rate of change, not the amount; legacy keyed option C.
  • Original Q15: verified as keyed. mf = frequency deviation / modulating frequency, which none of A-C states (deviation/75 kHz is percentage modulation); legacy keyed option A.
  • Original Q16: verified as keyed. mf = deviation / modulating frequency; key unchanged.
  • Original Q17: verified as keyed. Polarization is defined by the electric field orientation; key unchanged.
  • Original Q18: verified as keyed. Transverse Magnetic: the magnetic field has no component along the direction of propagation; key unchanged.
  • Original Q19: verified as keyed. A hollow single-conductor waveguide supports only TE/TM modes, never TEM; legacy keyed 'Not necessarily'.
  • Original Q20: verified as keyed. Coaxial cable is the standard TV feeder; key unchanged.
  • Original Q21: verified as keyed. Gamma = (ZL - Z0)/(ZL + Z0) = -1/3 gives ZL = 150 ohms (the +1/3 case gives 600, not offered); key unchanged.
  • Original Q22: verified as keyed. Solar ultraviolet and X-ray radiation ionizes the upper atmosphere; legacy keyed 'Pressure variations with altitude'.
  • Original Q23: verified as keyed. It/Ic = sqrt(1 + m^2/2) = sqrt(1.32) = 1.149, about 15% greater; key unchanged.
  • Original Q24: verified as keyed. Fidelity (faithful reproduction) is set by the audio stage's frequency response; key unchanged.
  • Original Q25: verified as keyed. Video spans from tens of Hz to about 4.5 MHz, roughly 18 octaves; legacy keyed 4 octaves.
  • Original Q26: verified as keyed. Brightness is set by varying the DC bias of the picture tube's grid-cathode circuit; legacy keyed 'Audio Section'.
  • Original Q27: verified as keyed. Fine tuning slightly varies the local oscillator frequency, commonly via a potentiometer adjusting a varactor diode (variable capacitors/inductors were also used); key unchanged. Fixed misprint 'condensor'.
  • Original Q28: verified as keyed. FCC/NTSC line frequency is 15,750 Hz (CCIR is 15,625 Hz; 50/60 Hz are field rates); legacy keyed option D.
  • Original Q29: verified as keyed. For the same lens focal length, the larger image (target) size of the 4.5 inch tube covers a wider angle of view; legacy keyed 'None of these'.
  • Original Q30: verified as keyed. The 4:3 aspect ratio suits scenes whose action and the human field of view are predominantly horizontal; legacy keyed 'Horizontal deflection frequency is higher'. Fixed misprint 'rastar'.
  • Original Q31: Legacy options were 'Base / AB / B / C' - the option list is mangled beyond repair (a PNP transistor has base, emitter and collector regions), so no defensible answer can be constructed. Dropped as unfixable.