Уровень 2
30 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.
Answers and sources
Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.
Question 1: answer and source
The Laplace transform of an impulse function is
Answer: 1
L{delta(t)} = 1; key unchanged.
Question 2: answer and source
The effective area of an isotropic radiator is
Answer: (L * L) / 4P
Effective aperture of an isotropic antenna = lambda^2 / (4 pi), written here with L for wavelength and P for pi; key unchanged.
Question 3: answer and source
The Q factor of a coil can be given as
Answer: wL / R
Quality factor of an inductor Q = omega L / R; key unchanged.
Question 4: answer and source
The VSWR of a transmission line is 4, its reflection coefficient is
Answer: 0.6
|Gamma| = (VSWR - 1)/(VSWR + 1) = 3/5 = 0.6; key unchanged.
Question 5: answer and source
If the load impedance connected to a transmission line of characteristic impedance 50 ohms is 150 ohms, its reflection coefficient is
Answer: 0.5
Gamma = (ZL - Z0)/(ZL + Z0) = (150 - 50)/200 = 0.5; key unchanged.
Question 6: answer and source
The charge contained in an electron is
Answer: -1.6 x 10^-19 Coulomb
Elementary charge e = 1.6 x 10^-19 C, negative for the electron; key unchanged.
Question 7: answer and source
Most commonly used materials as photo cathode for the photoelectric emission are
Answer: Cesium and Rubidium
Standard photocathodes use alkali metals: Ag-O-Cs, Sb-Cs and bi/tri-alkali compounds including SbRbCs (caesium and rubidium); legacy keyed 'Arsenic and Boron' (those are semiconductor dopants). Fixed misprint 'Ribidium'.
Question 8: answer and source
Current through the ionized gas in gas tube
Answer: Usually fluctuates
A gas discharge is inherently unstable and the current is set by the external circuit, so it usually fluctuates (the tube holds a nearly constant voltage drop instead); legacy keyed 'infinity', which is physically impossible.
Question 9: answer and source
Semi-conductor diode time constant is equal to
Answer: The life time of minority carrier
Diode storage/switching time is governed by the minority carrier lifetime, not the majority carriers; legacy keyed majority carrier life time.
Question 10: answer and source
To prepare a P type semiconducting material the impurities to be added to silicon are
Answer: Boron, Gallium
P-type doping uses trivalent (group III) acceptors such as boron and gallium; key unchanged.
Question 11: answer and source
FET is a good signal chopper because
Answer: It exhibits no offset voltage at zero drain current
A FET chopper shows no offset voltage at zero drain current, unlike a BJT; key unchanged.
Question 12: answer and source
In Bipolar Junction transistors, the type of configuration which will give both voltage gain and current gain is
Answer: CE
Common-emitter gives both voltage and current gain (CB: no current gain, CC: no voltage gain); key unchanged.
Question 13: answer and source
The (V^d) - (I^d) characteristics of an FET are similar to that of
Answer: Pentode
FET drain characteristics saturate like a pentode's plate characteristics; key unchanged. Fixed misprint 'None of there'.
Question 14: answer and source
The transformer utilization factor for a bridge rectifier is given as
Answer: 0.812
TUF of a bridge rectifier = 0.812 (centre-tap secondary: 0.693, primary 0.287); key unchanged.
Question 15: answer and source
To increase the input resistance and decrease the output resistance in negative feedback, the type used is
Answer: Voltage Series
Series mixing raises input resistance; voltage sampling lowers output resistance; key unchanged.
Question 16: answer and source
The coupling capacitance of a bipolar transistor amplifier must be
Answer: 500 times larger than the FET amplifier
A BJT's low input impedance needs a much larger coupling capacitor than a high-input-impedance FET stage for the same low-frequency cutoff; key unchanged.
Question 17: answer and source
The closed-loop gain of an amplifier employing negative feedback (feedback ratio B) with a large loop gain is approximately
Answer: 1 / B
Af = A/(1 + AB), which tends to 1/B when the loop gain AB is large; stem repaired from the corrupted legacy wording ('loop gain ... is 1/B').
Question 18: answer and source
The value of a resistor creating thermal noise is doubled. The noise power generator is therefore
Answer: Unchanged
Available thermal noise power = kTB, independent of resistance (the noise voltage rises as sqrt(R)); key unchanged.
Question 19: answer and source
In every practical oscillator the loop gain is
Answer: Slightly larger than unity
Practical oscillators start with loop gain slightly above 1 and settle to unity; key unchanged.
Question 20: answer and source
Alternatively the characteristic impedance is called
Answer: Surge Impedance
Characteristic impedance is also called surge impedance; key unchanged.
Question 21: answer and source
For any uniform and symmetrical line the characteristic impedance is
Answer: The geometric mean of the open and short circuited impedances
Z0 = sqrt(Zoc . Zsc); key unchanged. Fixed misprint 'symmetrical life'.
Question 22: answer and source
The gain bandwidth product of the transistor amplifier is usually denoted as
Answer: None of these
The gain-bandwidth product is denoted fT (transition frequency, where |hfe| = 1); none of the listed symbols is fT; legacy keyed f^y.
Question 23: answer and source
In crystal oscillators, the valuable properties of a crystal are
Answer: High Q and high L/C ratio
Crystals offer very high Q and a high L/C ratio, giving stable oscillation; key unchanged.
Question 24: answer and source
In an RL circuit after a very long time of application of step voltage the inductance L is represented in its equivalent circuit as
Answer: Short Circuit
At DC steady state an inductor acts as a short circuit; key unchanged.
Question 25: answer and source
Thevenin's theorem cannot be applied to a network which contains
Answer: Nonlinear impedances
Thevenin's theorem applies only to linear networks; key unchanged.
Question 26: answer and source
The loss produced by the insertion of the network of line is referred to as the
Answer: Insertion Loss
Loss due to inserting a network into a line is insertion loss; key unchanged.
Question 27: answer and source
A series capacitance used in a filter circuit represents
Answer: High-Pass
A series capacitor blocks low frequencies and passes high frequencies: high-pass; key unchanged.
Question 28: answer and source
Photo multipliers make use of
Answer: Secondary Emission
Photomultiplier dynodes multiply electrons by secondary emission; key unchanged. Fixed stem misprint 'Photoemission multipliers'.
Question 29: answer and source
The reflection coefficient on a lossless line with a short circuit load, is given by
Answer: -1
For a short circuit ZL = 0, Gamma = (0 - Z0)/(0 + Z0) = -1; key unchanged. Fixed misprint 'Lamda'.
Question 30: answer and source
By passing a triangular wave through a differentiating circuit the output wave shape is
Answer: Squarewave
The derivative of a triangular wave is a square wave (differentiating a square wave gives spikes); legacy keyed 'Spikes'.
Change log: 17 November 2026
Original question numbers and review decisions
- Original Q1: verified as keyed. L{delta(t)} = 1; key unchanged.
- Original Q2: verified as keyed. Effective aperture of an isotropic antenna = lambda^2 / (4 pi), written here with L for wavelength and P for pi; key unchanged.
- Original Q3: verified as keyed. Quality factor of an inductor Q = omega L / R; key unchanged.
- Original Q4: verified as keyed. |Gamma| = (VSWR - 1)/(VSWR + 1) = 3/5 = 0.6; key unchanged.
- Original Q5: verified as keyed. Gamma = (ZL - Z0)/(ZL + Z0) = (150 - 50)/200 = 0.5; key unchanged.
- Original Q6: verified as keyed. Elementary charge e = 1.6 x 10^-19 C, negative for the electron; key unchanged.
- Original Q7: verified as keyed. Standard photocathodes use alkali metals: Ag-O-Cs, Sb-Cs and bi/tri-alkali compounds including SbRbCs (caesium and rubidium); legacy keyed 'Arsenic and Boron' (those are semiconductor dopants). Fixed misprint 'Ribidium'.
- Original Q8: verified as keyed. A gas discharge is inherently unstable and the current is set by the external circuit, so it usually fluctuates (the tube holds a nearly constant voltage drop instead); legacy keyed 'infinity', which is physically impossible.
- Original Q9: verified as keyed. Diode storage/switching time is governed by the minority carrier lifetime, not the majority carriers; legacy keyed majority carrier life time.
- Original Q10: verified as keyed. P-type doping uses trivalent (group III) acceptors such as boron and gallium; key unchanged.
- Original Q11: verified as keyed. A FET chopper shows no offset voltage at zero drain current, unlike a BJT; key unchanged.
- Original Q12: verified as keyed. Common-emitter gives both voltage and current gain (CB: no current gain, CC: no voltage gain); key unchanged.
- Original Q13: verified as keyed. FET drain characteristics saturate like a pentode's plate characteristics; key unchanged. Fixed misprint 'None of there'.
- Original Q14: verified as keyed. TUF of a bridge rectifier = 0.812 (centre-tap secondary: 0.693, primary 0.287); key unchanged.
- Original Q15: verified as keyed. Series mixing raises input resistance; voltage sampling lowers output resistance; key unchanged.
- Original Q16: verified as keyed. A BJT's low input impedance needs a much larger coupling capacitor than a high-input-impedance FET stage for the same low-frequency cutoff; key unchanged.
- Original Q17: corrected. Af = A/(1 + AB), which tends to 1/B when the loop gain AB is large; stem repaired from the corrupted legacy wording ('loop gain ... is 1/B').
- Original Q18: verified as keyed. Available thermal noise power = kTB, independent of resistance (the noise voltage rises as sqrt(R)); key unchanged.
- Original Q19: verified as keyed. Practical oscillators start with loop gain slightly above 1 and settle to unity; key unchanged.
- Original Q20: verified as keyed. Characteristic impedance is also called surge impedance; key unchanged.
- Original Q21: verified as keyed. Z0 = sqrt(Zoc . Zsc); key unchanged. Fixed misprint 'symmetrical life'.
- Original Q22: verified as keyed. The gain-bandwidth product is denoted fT (transition frequency, where |hfe| = 1); none of the listed symbols is fT; legacy keyed f^y.
- Original Q23: verified as keyed. Crystals offer very high Q and a high L/C ratio, giving stable oscillation; key unchanged.
- Original Q24: verified as keyed. At DC steady state an inductor acts as a short circuit; key unchanged.
- Original Q25: verified as keyed. Thevenin's theorem applies only to linear networks; key unchanged.
- Original Q26: verified as keyed. Loss due to inserting a network into a line is insertion loss; key unchanged.
- Original Q27: verified as keyed. A series capacitor blocks low frequencies and passes high frequencies: high-pass; key unchanged.
- Original Q28: verified as keyed. Photomultiplier dynodes multiply electrons by secondary emission; key unchanged. Fixed stem misprint 'Photoemission multipliers'.
- Original Q29: verified as keyed. For a short circuit ZL = 0, Gamma = (0 - Z0)/(0 + Z0) = -1; key unchanged. Fixed misprint 'Lamda'.
- Original Q30: verified as keyed. The derivative of a triangular wave is a square wave (differentiating a square wave gives spikes); legacy keyed 'Spikes'.