Stufe 2


30 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.

Geben Sie Ihre Werte ein:
Ergebnisse:
%

Answers and sources

Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.

Question 1: answer and source

The Laplace transform of an impulse function is

Answer: 1

L{delta(t)} = 1; key unchanged.

Question 2: answer and source

The effective area of an isotropic radiator is

Answer: (L * L) / 4P

Effective aperture of an isotropic antenna = lambda^2 / (4 pi), written here with L for wavelength and P for pi; key unchanged.

Question 3: answer and source

The Q factor of a coil can be given as

Answer: wL / R

Quality factor of an inductor Q = omega L / R; key unchanged.

Question 4: answer and source

The VSWR of a transmission line is 4, its reflection coefficient is

Answer: 0.6

|Gamma| = (VSWR - 1)/(VSWR + 1) = 3/5 = 0.6; key unchanged.

Question 5: answer and source

If the load impedance connected to a transmission line of characteristic impedance 50 ohms is 150 ohms, its reflection coefficient is

Answer: 0.5

Gamma = (ZL - Z0)/(ZL + Z0) = (150 - 50)/200 = 0.5; key unchanged.

Question 6: answer and source

The charge contained in an electron is

Answer: -1.6 x 10^-19 Coulomb

Elementary charge e = 1.6 x 10^-19 C, negative for the electron; key unchanged.

Question 7: answer and source

Most commonly used materials as photo cathode for the photoelectric emission are

Answer: Cesium and Rubidium

Standard photocathodes use alkali metals: Ag-O-Cs, Sb-Cs and bi/tri-alkali compounds including SbRbCs (caesium and rubidium); legacy keyed 'Arsenic and Boron' (those are semiconductor dopants). Fixed misprint 'Ribidium'.

Source 1

Question 8: answer and source

Current through the ionized gas in gas tube

Answer: Usually fluctuates

A gas discharge is inherently unstable and the current is set by the external circuit, so it usually fluctuates (the tube holds a nearly constant voltage drop instead); legacy keyed 'infinity', which is physically impossible.

Source 1

Question 9: answer and source

Semi-conductor diode time constant is equal to

Answer: The life time of minority carrier

Diode storage/switching time is governed by the minority carrier lifetime, not the majority carriers; legacy keyed majority carrier life time.

Source 1

Question 10: answer and source

To prepare a P type semiconducting material the impurities to be added to silicon are

Answer: Boron, Gallium

P-type doping uses trivalent (group III) acceptors such as boron and gallium; key unchanged.

Question 11: answer and source

FET is a good signal chopper because

Answer: It exhibits no offset voltage at zero drain current

A FET chopper shows no offset voltage at zero drain current, unlike a BJT; key unchanged.

Question 12: answer and source

In Bipolar Junction transistors, the type of configuration which will give both voltage gain and current gain is

Answer: CE

Common-emitter gives both voltage and current gain (CB: no current gain, CC: no voltage gain); key unchanged.

Question 13: answer and source

The (V^d) - (I^d) characteristics of an FET are similar to that of

Answer: Pentode

FET drain characteristics saturate like a pentode's plate characteristics; key unchanged. Fixed misprint 'None of there'.

Question 14: answer and source

The transformer utilization factor for a bridge rectifier is given as

Answer: 0.812

TUF of a bridge rectifier = 0.812 (centre-tap secondary: 0.693, primary 0.287); key unchanged.

Question 15: answer and source

To increase the input resistance and decrease the output resistance in negative feedback, the type used is

Answer: Voltage Series

Series mixing raises input resistance; voltage sampling lowers output resistance; key unchanged.

Question 16: answer and source

The coupling capacitance of a bipolar transistor amplifier must be

Answer: 500 times larger than the FET amplifier

A BJT's low input impedance needs a much larger coupling capacitor than a high-input-impedance FET stage for the same low-frequency cutoff; key unchanged.

Question 17: answer and source

The closed-loop gain of an amplifier employing negative feedback (feedback ratio B) with a large loop gain is approximately

Answer: 1 / B

Af = A/(1 + AB), which tends to 1/B when the loop gain AB is large; stem repaired from the corrupted legacy wording ('loop gain ... is 1/B').

Source 1

Question 18: answer and source

The value of a resistor creating thermal noise is doubled. The noise power generator is therefore

Answer: Unchanged

Available thermal noise power = kTB, independent of resistance (the noise voltage rises as sqrt(R)); key unchanged.

Question 19: answer and source

In every practical oscillator the loop gain is

Answer: Slightly larger than unity

Practical oscillators start with loop gain slightly above 1 and settle to unity; key unchanged.

Question 20: answer and source

Alternatively the characteristic impedance is called

Answer: Surge Impedance

Characteristic impedance is also called surge impedance; key unchanged.

Question 21: answer and source

For any uniform and symmetrical line the characteristic impedance is

Answer: The geometric mean of the open and short circuited impedances

Z0 = sqrt(Zoc . Zsc); key unchanged. Fixed misprint 'symmetrical life'.

Question 22: answer and source

The gain bandwidth product of the transistor amplifier is usually denoted as

Answer: None of these

The gain-bandwidth product is denoted fT (transition frequency, where |hfe| = 1); none of the listed symbols is fT; legacy keyed f^y.

Source 1

Question 23: answer and source

In crystal oscillators, the valuable properties of a crystal are

Answer: High Q and high L/C ratio

Crystals offer very high Q and a high L/C ratio, giving stable oscillation; key unchanged.

Question 24: answer and source

In an RL circuit after a very long time of application of step voltage the inductance L is represented in its equivalent circuit as

Answer: Short Circuit

At DC steady state an inductor acts as a short circuit; key unchanged.

Question 25: answer and source

Thevenin's theorem cannot be applied to a network which contains

Answer: Nonlinear impedances

Thevenin's theorem applies only to linear networks; key unchanged.

Question 26: answer and source

The loss produced by the insertion of the network of line is referred to as the

Answer: Insertion Loss

Loss due to inserting a network into a line is insertion loss; key unchanged.

Question 27: answer and source

A series capacitance used in a filter circuit represents

Answer: High-Pass

A series capacitor blocks low frequencies and passes high frequencies: high-pass; key unchanged.

Question 28: answer and source

Photo multipliers make use of

Answer: Secondary Emission

Photomultiplier dynodes multiply electrons by secondary emission; key unchanged. Fixed stem misprint 'Photoemission multipliers'.

Source 1

Question 29: answer and source

The reflection coefficient on a lossless line with a short circuit load, is given by

Answer: -1

For a short circuit ZL = 0, Gamma = (0 - Z0)/(0 + Z0) = -1; key unchanged. Fixed misprint 'Lamda'.

Question 30: answer and source

By passing a triangular wave through a differentiating circuit the output wave shape is

Answer: Squarewave

The derivative of a triangular wave is a square wave (differentiating a square wave gives spikes); legacy keyed 'Spikes'.

Change log: 17 November 2026

Original question numbers and review decisions
  • Original Q1: verified as keyed. L{delta(t)} = 1; key unchanged.
  • Original Q2: verified as keyed. Effective aperture of an isotropic antenna = lambda^2 / (4 pi), written here with L for wavelength and P for pi; key unchanged.
  • Original Q3: verified as keyed. Quality factor of an inductor Q = omega L / R; key unchanged.
  • Original Q4: verified as keyed. |Gamma| = (VSWR - 1)/(VSWR + 1) = 3/5 = 0.6; key unchanged.
  • Original Q5: verified as keyed. Gamma = (ZL - Z0)/(ZL + Z0) = (150 - 50)/200 = 0.5; key unchanged.
  • Original Q6: verified as keyed. Elementary charge e = 1.6 x 10^-19 C, negative for the electron; key unchanged.
  • Original Q7: verified as keyed. Standard photocathodes use alkali metals: Ag-O-Cs, Sb-Cs and bi/tri-alkali compounds including SbRbCs (caesium and rubidium); legacy keyed 'Arsenic and Boron' (those are semiconductor dopants). Fixed misprint 'Ribidium'.
  • Original Q8: verified as keyed. A gas discharge is inherently unstable and the current is set by the external circuit, so it usually fluctuates (the tube holds a nearly constant voltage drop instead); legacy keyed 'infinity', which is physically impossible.
  • Original Q9: verified as keyed. Diode storage/switching time is governed by the minority carrier lifetime, not the majority carriers; legacy keyed majority carrier life time.
  • Original Q10: verified as keyed. P-type doping uses trivalent (group III) acceptors such as boron and gallium; key unchanged.
  • Original Q11: verified as keyed. A FET chopper shows no offset voltage at zero drain current, unlike a BJT; key unchanged.
  • Original Q12: verified as keyed. Common-emitter gives both voltage and current gain (CB: no current gain, CC: no voltage gain); key unchanged.
  • Original Q13: verified as keyed. FET drain characteristics saturate like a pentode's plate characteristics; key unchanged. Fixed misprint 'None of there'.
  • Original Q14: verified as keyed. TUF of a bridge rectifier = 0.812 (centre-tap secondary: 0.693, primary 0.287); key unchanged.
  • Original Q15: verified as keyed. Series mixing raises input resistance; voltage sampling lowers output resistance; key unchanged.
  • Original Q16: verified as keyed. A BJT's low input impedance needs a much larger coupling capacitor than a high-input-impedance FET stage for the same low-frequency cutoff; key unchanged.
  • Original Q17: corrected. Af = A/(1 + AB), which tends to 1/B when the loop gain AB is large; stem repaired from the corrupted legacy wording ('loop gain ... is 1/B').
  • Original Q18: verified as keyed. Available thermal noise power = kTB, independent of resistance (the noise voltage rises as sqrt(R)); key unchanged.
  • Original Q19: verified as keyed. Practical oscillators start with loop gain slightly above 1 and settle to unity; key unchanged.
  • Original Q20: verified as keyed. Characteristic impedance is also called surge impedance; key unchanged.
  • Original Q21: verified as keyed. Z0 = sqrt(Zoc . Zsc); key unchanged. Fixed misprint 'symmetrical life'.
  • Original Q22: verified as keyed. The gain-bandwidth product is denoted fT (transition frequency, where |hfe| = 1); none of the listed symbols is fT; legacy keyed f^y.
  • Original Q23: verified as keyed. Crystals offer very high Q and a high L/C ratio, giving stable oscillation; key unchanged.
  • Original Q24: verified as keyed. At DC steady state an inductor acts as a short circuit; key unchanged.
  • Original Q25: verified as keyed. Thevenin's theorem applies only to linear networks; key unchanged.
  • Original Q26: verified as keyed. Loss due to inserting a network into a line is insertion loss; key unchanged.
  • Original Q27: verified as keyed. A series capacitor blocks low frequencies and passes high frequencies: high-pass; key unchanged.
  • Original Q28: verified as keyed. Photomultiplier dynodes multiply electrons by secondary emission; key unchanged. Fixed stem misprint 'Photoemission multipliers'.
  • Original Q29: verified as keyed. For a short circuit ZL = 0, Gamma = (0 - Z0)/(0 + Z0) = -1; key unchanged. Fixed misprint 'Lamda'.
  • Original Q30: verified as keyed. The derivative of a triangular wave is a square wave (differentiating a square wave gives spikes); legacy keyed 'Spikes'.