第 2 级


30 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.

请输入数值:
结果:
%

Answers and sources

Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.

Question 1: answer and source

The Laplace transform of an impulse function is

Answer: 1

L{delta(t)} = 1; key unchanged.

Question 2: answer and source

The effective area of an isotropic radiator is

Answer: (L * L) / 4P

Effective aperture of an isotropic antenna = lambda^2 / (4 pi), written here with L for wavelength and P for pi; key unchanged.

Question 3: answer and source

The Q factor of a coil can be given as

Answer: wL / R

Quality factor of an inductor Q = omega L / R; key unchanged.

Question 4: answer and source

The VSWR of a transmission line is 4, its reflection coefficient is

Answer: 0.6

|Gamma| = (VSWR - 1)/(VSWR + 1) = 3/5 = 0.6; key unchanged.

Question 5: answer and source

If the load impedance connected to a transmission line of characteristic impedance 50 ohms is 150 ohms, its reflection coefficient is

Answer: 0.5

Gamma = (ZL - Z0)/(ZL + Z0) = (150 - 50)/200 = 0.5; key unchanged.

Question 6: answer and source

The charge contained in an electron is

Answer: -1.6 x 10^-19 Coulomb

Elementary charge e = 1.6 x 10^-19 C, negative for the electron; key unchanged.

Question 7: answer and source

Most commonly used materials as photo cathode for the photoelectric emission are

Answer: Cesium and Rubidium

Standard photocathodes use alkali metals: Ag-O-Cs, Sb-Cs and bi/tri-alkali compounds including SbRbCs (caesium and rubidium); legacy keyed 'Arsenic and Boron' (those are semiconductor dopants). Fixed misprint 'Ribidium'.

Source 1

Question 8: answer and source

Current through the ionized gas in gas tube

Answer: Usually fluctuates

A gas discharge is inherently unstable and the current is set by the external circuit, so it usually fluctuates (the tube holds a nearly constant voltage drop instead); legacy keyed 'infinity', which is physically impossible.

Source 1

Question 9: answer and source

Semi-conductor diode time constant is equal to

Answer: The life time of minority carrier

Diode storage/switching time is governed by the minority carrier lifetime, not the majority carriers; legacy keyed majority carrier life time.

Source 1

Question 10: answer and source

To prepare a P type semiconducting material the impurities to be added to silicon are

Answer: Boron, Gallium

P-type doping uses trivalent (group III) acceptors such as boron and gallium; key unchanged.

Question 11: answer and source

FET is a good signal chopper because

Answer: It exhibits no offset voltage at zero drain current

A FET chopper shows no offset voltage at zero drain current, unlike a BJT; key unchanged.

Question 12: answer and source

In Bipolar Junction transistors, the type of configuration which will give both voltage gain and current gain is

Answer: CE

Common-emitter gives both voltage and current gain (CB: no current gain, CC: no voltage gain); key unchanged.

Question 13: answer and source

The (V^d) - (I^d) characteristics of an FET are similar to that of

Answer: Pentode

FET drain characteristics saturate like a pentode's plate characteristics; key unchanged. Fixed misprint 'None of there'.

Question 14: answer and source

The transformer utilization factor for a bridge rectifier is given as

Answer: 0.812

TUF of a bridge rectifier = 0.812 (centre-tap secondary: 0.693, primary 0.287); key unchanged.

Question 15: answer and source

To increase the input resistance and decrease the output resistance in negative feedback, the type used is

Answer: Voltage Series

Series mixing raises input resistance; voltage sampling lowers output resistance; key unchanged.

Question 16: answer and source

The coupling capacitance of a bipolar transistor amplifier must be

Answer: 500 times larger than the FET amplifier

A BJT's low input impedance needs a much larger coupling capacitor than a high-input-impedance FET stage for the same low-frequency cutoff; key unchanged.

Question 17: answer and source

The closed-loop gain of an amplifier employing negative feedback (feedback ratio B) with a large loop gain is approximately

Answer: 1 / B

Af = A/(1 + AB), which tends to 1/B when the loop gain AB is large; stem repaired from the corrupted legacy wording ('loop gain ... is 1/B').

Source 1

Question 18: answer and source

The value of a resistor creating thermal noise is doubled. The noise power generator is therefore

Answer: Unchanged

Available thermal noise power = kTB, independent of resistance (the noise voltage rises as sqrt(R)); key unchanged.

Question 19: answer and source

In every practical oscillator the loop gain is

Answer: Slightly larger than unity

Practical oscillators start with loop gain slightly above 1 and settle to unity; key unchanged.

Question 20: answer and source

Alternatively the characteristic impedance is called

Answer: Surge Impedance

Characteristic impedance is also called surge impedance; key unchanged.

Question 21: answer and source

For any uniform and symmetrical line the characteristic impedance is

Answer: The geometric mean of the open and short circuited impedances

Z0 = sqrt(Zoc . Zsc); key unchanged. Fixed misprint 'symmetrical life'.

Question 22: answer and source

The gain bandwidth product of the transistor amplifier is usually denoted as

Answer: None of these

The gain-bandwidth product is denoted fT (transition frequency, where |hfe| = 1); none of the listed symbols is fT; legacy keyed f^y.

Source 1

Question 23: answer and source

In crystal oscillators, the valuable properties of a crystal are

Answer: High Q and high L/C ratio

Crystals offer very high Q and a high L/C ratio, giving stable oscillation; key unchanged.

Question 24: answer and source

In an RL circuit after a very long time of application of step voltage the inductance L is represented in its equivalent circuit as

Answer: Short Circuit

At DC steady state an inductor acts as a short circuit; key unchanged.

Question 25: answer and source

Thevenin's theorem cannot be applied to a network which contains

Answer: Nonlinear impedances

Thevenin's theorem applies only to linear networks; key unchanged.

Question 26: answer and source

The loss produced by the insertion of the network of line is referred to as the

Answer: Insertion Loss

Loss due to inserting a network into a line is insertion loss; key unchanged.

Question 27: answer and source

A series capacitance used in a filter circuit represents

Answer: High-Pass

A series capacitor blocks low frequencies and passes high frequencies: high-pass; key unchanged.

Question 28: answer and source

Photo multipliers make use of

Answer: Secondary Emission

Photomultiplier dynodes multiply electrons by secondary emission; key unchanged. Fixed stem misprint 'Photoemission multipliers'.

Source 1

Question 29: answer and source

The reflection coefficient on a lossless line with a short circuit load, is given by

Answer: -1

For a short circuit ZL = 0, Gamma = (0 - Z0)/(0 + Z0) = -1; key unchanged. Fixed misprint 'Lamda'.

Question 30: answer and source

By passing a triangular wave through a differentiating circuit the output wave shape is

Answer: Squarewave

The derivative of a triangular wave is a square wave (differentiating a square wave gives spikes); legacy keyed 'Spikes'.

Change log: 17 November 2026

Original question numbers and review decisions
  • Original Q1: verified as keyed. L{delta(t)} = 1; key unchanged.
  • Original Q2: verified as keyed. Effective aperture of an isotropic antenna = lambda^2 / (4 pi), written here with L for wavelength and P for pi; key unchanged.
  • Original Q3: verified as keyed. Quality factor of an inductor Q = omega L / R; key unchanged.
  • Original Q4: verified as keyed. |Gamma| = (VSWR - 1)/(VSWR + 1) = 3/5 = 0.6; key unchanged.
  • Original Q5: verified as keyed. Gamma = (ZL - Z0)/(ZL + Z0) = (150 - 50)/200 = 0.5; key unchanged.
  • Original Q6: verified as keyed. Elementary charge e = 1.6 x 10^-19 C, negative for the electron; key unchanged.
  • Original Q7: verified as keyed. Standard photocathodes use alkali metals: Ag-O-Cs, Sb-Cs and bi/tri-alkali compounds including SbRbCs (caesium and rubidium); legacy keyed 'Arsenic and Boron' (those are semiconductor dopants). Fixed misprint 'Ribidium'.
  • Original Q8: verified as keyed. A gas discharge is inherently unstable and the current is set by the external circuit, so it usually fluctuates (the tube holds a nearly constant voltage drop instead); legacy keyed 'infinity', which is physically impossible.
  • Original Q9: verified as keyed. Diode storage/switching time is governed by the minority carrier lifetime, not the majority carriers; legacy keyed majority carrier life time.
  • Original Q10: verified as keyed. P-type doping uses trivalent (group III) acceptors such as boron and gallium; key unchanged.
  • Original Q11: verified as keyed. A FET chopper shows no offset voltage at zero drain current, unlike a BJT; key unchanged.
  • Original Q12: verified as keyed. Common-emitter gives both voltage and current gain (CB: no current gain, CC: no voltage gain); key unchanged.
  • Original Q13: verified as keyed. FET drain characteristics saturate like a pentode's plate characteristics; key unchanged. Fixed misprint 'None of there'.
  • Original Q14: verified as keyed. TUF of a bridge rectifier = 0.812 (centre-tap secondary: 0.693, primary 0.287); key unchanged.
  • Original Q15: verified as keyed. Series mixing raises input resistance; voltage sampling lowers output resistance; key unchanged.
  • Original Q16: verified as keyed. A BJT's low input impedance needs a much larger coupling capacitor than a high-input-impedance FET stage for the same low-frequency cutoff; key unchanged.
  • Original Q17: corrected. Af = A/(1 + AB), which tends to 1/B when the loop gain AB is large; stem repaired from the corrupted legacy wording ('loop gain ... is 1/B').
  • Original Q18: verified as keyed. Available thermal noise power = kTB, independent of resistance (the noise voltage rises as sqrt(R)); key unchanged.
  • Original Q19: verified as keyed. Practical oscillators start with loop gain slightly above 1 and settle to unity; key unchanged.
  • Original Q20: verified as keyed. Characteristic impedance is also called surge impedance; key unchanged.
  • Original Q21: verified as keyed. Z0 = sqrt(Zoc . Zsc); key unchanged. Fixed misprint 'symmetrical life'.
  • Original Q22: verified as keyed. The gain-bandwidth product is denoted fT (transition frequency, where |hfe| = 1); none of the listed symbols is fT; legacy keyed f^y.
  • Original Q23: verified as keyed. Crystals offer very high Q and a high L/C ratio, giving stable oscillation; key unchanged.
  • Original Q24: verified as keyed. At DC steady state an inductor acts as a short circuit; key unchanged.
  • Original Q25: verified as keyed. Thevenin's theorem applies only to linear networks; key unchanged.
  • Original Q26: verified as keyed. Loss due to inserting a network into a line is insertion loss; key unchanged.
  • Original Q27: verified as keyed. A series capacitor blocks low frequencies and passes high frequencies: high-pass; key unchanged.
  • Original Q28: verified as keyed. Photomultiplier dynodes multiply electrons by secondary emission; key unchanged. Fixed stem misprint 'Photoemission multipliers'.
  • Original Q29: verified as keyed. For a short circuit ZL = 0, Gamma = (0 - Z0)/(0 + Z0) = -1; key unchanged. Fixed misprint 'Lamda'.
  • Original Q30: verified as keyed. The derivative of a triangular wave is a square wave (differentiating a square wave gives spikes); legacy keyed 'Spikes'.