第 3 级


31 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.

请输入数值:
结果:
%

Answers and sources

Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.

Question 1: answer and source

Clipper circuits are used to obtain any one of the following waveforms

Answer: Smaller Amplitude

A clipper cuts off the part of the waveform above or below a reference level, giving a smaller amplitude output; key unchanged.

Question 2: answer and source

A pulse amplifier is basically an amplifier with

Answer: Wide Band

Faithful pulse amplification needs a wide bandwidth to preserve fast rise times; legacy keyed 'Narrow Band'.

Question 3: answer and source

Linearity of time base waveforms can be improved by using

Answer: Larger time constant

A larger RC time constant keeps the sweep on the initial, nearly linear part of the exponential; key unchanged.

Question 4: answer and source

For harmonic generation the amplifier used is

Answer: Class-C Tuned Amplifier

A class-C tuned amplifier's short conduction angle is rich in harmonics, selected by the tuned tank; key unchanged. Fixed misprints 'gerneration'/'Turned'.

Question 5: answer and source

Zener diodes semiconductors are

Answer: Heavily Doped

Zener diodes are heavily doped to give a thin depletion region and sharp breakdown; key unchanged.

Question 6: answer and source

Which of the following equation represent field strength H produced by a conductor carrying current I, at a distance r ?

Answer: H = I / (2 x PI x r)

Ampere's law around a long straight conductor: H = I / (2 pi r); key unchanged.

Question 7: answer and source

The relative permeability is considered as unity for

Answer: Air

Air is non-magnetic and its relative permeability is taken as unity in engineering work (vacuum is exactly 1; bismuth is diamagnetic, cobalt ferromagnetic); legacy keyed 'Cobalt'.

Source 1

Question 8: answer and source

A parallel polarized wave is incident from air to paraffin. If Er for paraffin is 2, the Brewster angle will be nearly equal to

Answer: 55 Degrees

tan(theta_B) = sqrt(2) = 1.414, so theta_B = 54.7 degrees; key unchanged. Fixed misprint 'paralled'.

Question 9: answer and source

Absolute Permeability is equal to

Answer: 4 x PI x 10^-7 H/m

mu0 = 4 pi x 10^-7 H/m; key unchanged.

Question 10: answer and source

The absorption of radio waves by the atmosphere depends on which of the following ?

Answer: Their frequency

Atmospheric absorption is strongly frequency dependent; key unchanged.

Question 11: answer and source

Plasma is

Answer: A gaseous medium

Plasma is an ionized gaseous medium; key unchanged.

Question 12: answer and source

Circular polarization is said to take place when

Answer: The magnitude is the same and the phase difference is 90 degs.

Circular polarization needs equal-amplitude orthogonal components in 90 degree phase difference; key unchanged.

Question 13: answer and source

The velocity of electromagnetic waves in a dielectric medium Er = 4 is equal to

Answer: 1.5 x 10^8 metres / second

v = c / sqrt(Er) = 3 x 10^8 / 2 = 1.5 x 10^8 m/s; key unchanged.

Question 14: answer and source

A plane wave travelling in air is normally incident on a block of paraffin with Er = 2.2. The reflection coefficient will be equal to

Answer: -0.195

Gamma = (1 - sqrt(2.2)) / (1 + sqrt(2.2)) = -0.483/2.483 = -0.195; legacy keyed -0.255.

Question 15: answer and source

For different loads the range of the values for VSWR is

Answer: 1 to Infinity

VSWR ranges from 1 (matched) to infinity (total reflection); key unchanged.

Question 16: answer and source

When the distance between two charges is doubled, the force between them will be equal to

Answer: One Fourth

Coulomb's law is inverse square: doubling distance quarters the force; key unchanged.

Question 17: answer and source

If the conductivity of copper is 5.8 x 10^7 mho / m and its relative permeability and permittivity is unity, then its refractive index at 10 MHz will be equal to

Answer: 2.27 x 10^5

For a good conductor n = sqrt(sigma / (2 x 2 pi f x e0)) = sqrt(5.8e7 / 1.113e-3) = 2.28 x 10^5. The legacy options had lost their exponents (2.27 / 22.7 / 227 / 2270); repaired with the correct powers of ten.

Source 1

Question 18: answer and source

A sinusoidal plane wave is transmitted through a medium whose breakdown strength is 30 KV / m and whose relative permeability is 4. The mean possible r.m.s power flow density will be

Answer: 2390 KW / metre

Poynting density S = E^2 / eta; with eta = 377 ohms, S = (30 kV/m)^2 / 377 = 2.39 x 10^6 W/m^2 = 2390 KW/m^2 (GATE ECE 2001 pattern). The stated mur = 4 does not enter the corpus computation; option units should read per square metre.

Source 1

Question 19: answer and source

Which of the following is ferromagnetic material ?

Answer: Cobalt

Iron, cobalt and nickel are the common ferromagnetic metals; key unchanged.

Question 20: answer and source

Response curve of an amplifier is a graph that shows

Answer: Variation of output voltage with frequency

A frequency response curve plots output (gain) against frequency; key unchanged.

Question 21: answer and source

In FET amplifiers, input is

Answer: A voltage signal

A FET is a voltage-controlled device with a high-impedance gate; key unchanged.

Question 22: answer and source

Decibel is defined in terms of

Answer: Power Ratio

The decibel is defined as 10 log10(power ratio); key unchanged.

Question 23: answer and source

A source of 500 Kilo Ohms output impedance was to be connected to a load of 10 Ohms. The matching device or circuit could be of two types: a CC stage in between, or a passive circuit with input and output impedances of 500 kilo ohms and 10 ohms. Finally, CC stage is preferred even though it demanded more component count and circuit complexity. Why ?

Answer: It does not alter circuit conditions because of its voltage gain being unity.

An emitter follower (CC) buffers with unity voltage gain, so it does not disturb circuit conditions; key unchanged. Fixed misprint 'preffered' and removed duplicated sentence.

Question 24: answer and source

Mark the reason for CB configuration having very small input impedance

Answer: That input is applied between emitter and base and emitter junction is always forward biased for operation

The CB input looks into the forward-biased emitter junction, hence very low input impedance; key unchanged. Fixed misprint 'emiiter'.

Question 25: answer and source

The power handling capability of a given transistor, is dependent upon which of the following ?

Answer: Maximum junction temperature and expected ambient temperature.

Allowed dissipation depends on both the maximum junction temperature and the ambient temperature (derating); key unchanged.

Question 26: answer and source

It is desired to design an amplifier with a voltage gain of 10,000. Output should be in phase with the input. Available CB stage has a gain of 100 per stage and CE has per stage gain of 25. The designed amplifier shall have

Answer: Two cascaded stages of CB configuration

Two CB stages give 100 x 100 = 10,000 and CB is non-inverting, so output stays in phase; four CE stages would give 25^4 = 390,625. Legacy keyed 'Four cascaded stages of CE'.

Question 27: answer and source

H-parameters of a transistor

Answer: Are dependent upon collector current

H-parameters are specified at an operating point and depend on collector current; key unchanged.

Question 28: answer and source

High frequency response of a transformer coupled amplifier is generally limited by

Answer: Transformer's leakage inductance and distributed capacitance

Leakage inductance with distributed (winding) capacitance limits the high-frequency end; key unchanged.

Question 29: answer and source

Low frequency response of a transformer coupled amplifier is limited by

Answer: Transformer's primary inductance

The shunting effect of finite primary (magnetizing) inductance limits low frequencies; key unchanged.

Question 30: answer and source

In a voltage series feedback

Answer: Output resistance decreases while input resistance increases

Series mixing raises input resistance; voltage sampling lowers output resistance; legacy keyed 'both reduced'.

Source 1

Question 31: answer and source

Which coupling produces the minimum interference with frequency response ?

Answer: Direct Coupling

Direct coupling has no reactive coupling elements, so it disturbs the frequency response least; key unchanged.

Change log: 17 November 2026

Original question numbers and review decisions
  • Original Q1: verified as keyed. A clipper cuts off the part of the waveform above or below a reference level, giving a smaller amplitude output; key unchanged.
  • Original Q2: verified as keyed. Faithful pulse amplification needs a wide bandwidth to preserve fast rise times; legacy keyed 'Narrow Band'.
  • Original Q3: verified as keyed. A larger RC time constant keeps the sweep on the initial, nearly linear part of the exponential; key unchanged.
  • Original Q4: verified as keyed. A class-C tuned amplifier's short conduction angle is rich in harmonics, selected by the tuned tank; key unchanged. Fixed misprints 'gerneration'/'Turned'.
  • Original Q5: verified as keyed. Zener diodes are heavily doped to give a thin depletion region and sharp breakdown; key unchanged.
  • Original Q6: verified as keyed. Ampere's law around a long straight conductor: H = I / (2 pi r); key unchanged.
  • Original Q7: verified as keyed. Air is non-magnetic and its relative permeability is taken as unity in engineering work (vacuum is exactly 1; bismuth is diamagnetic, cobalt ferromagnetic); legacy keyed 'Cobalt'.
  • Original Q8: verified as keyed. tan(theta_B) = sqrt(2) = 1.414, so theta_B = 54.7 degrees; key unchanged. Fixed misprint 'paralled'.
  • Original Q9: verified as keyed. mu0 = 4 pi x 10^-7 H/m; key unchanged.
  • Original Q10: verified as keyed. Atmospheric absorption is strongly frequency dependent; key unchanged.
  • Original Q11: verified as keyed. Plasma is an ionized gaseous medium; key unchanged.
  • Original Q12: verified as keyed. Circular polarization needs equal-amplitude orthogonal components in 90 degree phase difference; key unchanged.
  • Original Q13: verified as keyed. v = c / sqrt(Er) = 3 x 10^8 / 2 = 1.5 x 10^8 m/s; key unchanged.
  • Original Q14: verified as keyed. Gamma = (1 - sqrt(2.2)) / (1 + sqrt(2.2)) = -0.483/2.483 = -0.195; legacy keyed -0.255.
  • Original Q15: verified as keyed. VSWR ranges from 1 (matched) to infinity (total reflection); key unchanged.
  • Original Q16: verified as keyed. Coulomb's law is inverse square: doubling distance quarters the force; key unchanged.
  • Original Q17: corrected. For a good conductor n = sqrt(sigma / (2 x 2 pi f x e0)) = sqrt(5.8e7 / 1.113e-3) = 2.28 x 10^5. The legacy options had lost their exponents (2.27 / 22.7 / 227 / 2270); repaired with the correct powers of ten.
  • Original Q18: verified as keyed. Poynting density S = E^2 / eta; with eta = 377 ohms, S = (30 kV/m)^2 / 377 = 2.39 x 10^6 W/m^2 = 2390 KW/m^2 (GATE ECE 2001 pattern). The stated mur = 4 does not enter the corpus computation; option units should read per square metre.
  • Original Q19: verified as keyed. Iron, cobalt and nickel are the common ferromagnetic metals; key unchanged.
  • Original Q20: verified as keyed. A frequency response curve plots output (gain) against frequency; key unchanged.
  • Original Q21: verified as keyed. A FET is a voltage-controlled device with a high-impedance gate; key unchanged.
  • Original Q22: verified as keyed. The decibel is defined as 10 log10(power ratio); key unchanged.
  • Original Q23: verified as keyed. An emitter follower (CC) buffers with unity voltage gain, so it does not disturb circuit conditions; key unchanged. Fixed misprint 'preffered' and removed duplicated sentence.
  • Original Q24: verified as keyed. The CB input looks into the forward-biased emitter junction, hence very low input impedance; key unchanged. Fixed misprint 'emiiter'.
  • Original Q25: verified as keyed. Allowed dissipation depends on both the maximum junction temperature and the ambient temperature (derating); key unchanged.
  • Original Q26: verified as keyed. Two CB stages give 100 x 100 = 10,000 and CB is non-inverting, so output stays in phase; four CE stages would give 25^4 = 390,625. Legacy keyed 'Four cascaded stages of CE'.
  • Original Q27: verified as keyed. H-parameters are specified at an operating point and depend on collector current; key unchanged.
  • Original Q28: verified as keyed. Leakage inductance with distributed (winding) capacitance limits the high-frequency end; key unchanged.
  • Original Q29: verified as keyed. The shunting effect of finite primary (magnetizing) inductance limits low frequencies; key unchanged.
  • Original Q30: verified as keyed. Series mixing raises input resistance; voltage sampling lowers output resistance; legacy keyed 'both reduced'.
  • Original Q31: verified as keyed. Direct coupling has no reactive coupling elements, so it disturbs the frequency response least; key unchanged.