Stufe 3


31 reviewed questions. Choose answers, then Calculate. Clear resets all selections. Unanswered questions score zero and remain in the percentage denominator. Open the answer review below for sources.

Geben Sie Ihre Werte ein:
Ergebnisse:
%

Answers and sources

Reviewed 17 November 2026. Ambiguous, malformed and unverified legacy questions have been removed. Wording and answer choices have been corrected where needed. This is a study quiz, not certification of engineering or laboratory decisions.

Question 1: answer and source

Clipper circuits are used to obtain any one of the following waveforms

Answer: Smaller Amplitude

A clipper cuts off the part of the waveform above or below a reference level, giving a smaller amplitude output; key unchanged.

Question 2: answer and source

A pulse amplifier is basically an amplifier with

Answer: Wide Band

Faithful pulse amplification needs a wide bandwidth to preserve fast rise times; legacy keyed 'Narrow Band'.

Question 3: answer and source

Linearity of time base waveforms can be improved by using

Answer: Larger time constant

A larger RC time constant keeps the sweep on the initial, nearly linear part of the exponential; key unchanged.

Question 4: answer and source

For harmonic generation the amplifier used is

Answer: Class-C Tuned Amplifier

A class-C tuned amplifier's short conduction angle is rich in harmonics, selected by the tuned tank; key unchanged. Fixed misprints 'gerneration'/'Turned'.

Question 5: answer and source

Zener diodes semiconductors are

Answer: Heavily Doped

Zener diodes are heavily doped to give a thin depletion region and sharp breakdown; key unchanged.

Question 6: answer and source

Which of the following equation represent field strength H produced by a conductor carrying current I, at a distance r ?

Answer: H = I / (2 x PI x r)

Ampere's law around a long straight conductor: H = I / (2 pi r); key unchanged.

Question 7: answer and source

The relative permeability is considered as unity for

Answer: Air

Air is non-magnetic and its relative permeability is taken as unity in engineering work (vacuum is exactly 1; bismuth is diamagnetic, cobalt ferromagnetic); legacy keyed 'Cobalt'.

Source 1

Question 8: answer and source

A parallel polarized wave is incident from air to paraffin. If Er for paraffin is 2, the Brewster angle will be nearly equal to

Answer: 55 Degrees

tan(theta_B) = sqrt(2) = 1.414, so theta_B = 54.7 degrees; key unchanged. Fixed misprint 'paralled'.

Question 9: answer and source

Absolute Permeability is equal to

Answer: 4 x PI x 10^-7 H/m

mu0 = 4 pi x 10^-7 H/m; key unchanged.

Question 10: answer and source

The absorption of radio waves by the atmosphere depends on which of the following ?

Answer: Their frequency

Atmospheric absorption is strongly frequency dependent; key unchanged.

Question 11: answer and source

Plasma is

Answer: A gaseous medium

Plasma is an ionized gaseous medium; key unchanged.

Question 12: answer and source

Circular polarization is said to take place when

Answer: The magnitude is the same and the phase difference is 90 degs.

Circular polarization needs equal-amplitude orthogonal components in 90 degree phase difference; key unchanged.

Question 13: answer and source

The velocity of electromagnetic waves in a dielectric medium Er = 4 is equal to

Answer: 1.5 x 10^8 metres / second

v = c / sqrt(Er) = 3 x 10^8 / 2 = 1.5 x 10^8 m/s; key unchanged.

Question 14: answer and source

A plane wave travelling in air is normally incident on a block of paraffin with Er = 2.2. The reflection coefficient will be equal to

Answer: -0.195

Gamma = (1 - sqrt(2.2)) / (1 + sqrt(2.2)) = -0.483/2.483 = -0.195; legacy keyed -0.255.

Question 15: answer and source

For different loads the range of the values for VSWR is

Answer: 1 to Infinity

VSWR ranges from 1 (matched) to infinity (total reflection); key unchanged.

Question 16: answer and source

When the distance between two charges is doubled, the force between them will be equal to

Answer: One Fourth

Coulomb's law is inverse square: doubling distance quarters the force; key unchanged.

Question 17: answer and source

If the conductivity of copper is 5.8 x 10^7 mho / m and its relative permeability and permittivity is unity, then its refractive index at 10 MHz will be equal to

Answer: 2.27 x 10^5

For a good conductor n = sqrt(sigma / (2 x 2 pi f x e0)) = sqrt(5.8e7 / 1.113e-3) = 2.28 x 10^5. The legacy options had lost their exponents (2.27 / 22.7 / 227 / 2270); repaired with the correct powers of ten.

Source 1

Question 18: answer and source

A sinusoidal plane wave is transmitted through a medium whose breakdown strength is 30 KV / m and whose relative permeability is 4. The mean possible r.m.s power flow density will be

Answer: 2390 KW / metre

Poynting density S = E^2 / eta; with eta = 377 ohms, S = (30 kV/m)^2 / 377 = 2.39 x 10^6 W/m^2 = 2390 KW/m^2 (GATE ECE 2001 pattern). The stated mur = 4 does not enter the corpus computation; option units should read per square metre.

Source 1

Question 19: answer and source

Which of the following is ferromagnetic material ?

Answer: Cobalt

Iron, cobalt and nickel are the common ferromagnetic metals; key unchanged.

Question 20: answer and source

Response curve of an amplifier is a graph that shows

Answer: Variation of output voltage with frequency

A frequency response curve plots output (gain) against frequency; key unchanged.

Question 21: answer and source

In FET amplifiers, input is

Answer: A voltage signal

A FET is a voltage-controlled device with a high-impedance gate; key unchanged.

Question 22: answer and source

Decibel is defined in terms of

Answer: Power Ratio

The decibel is defined as 10 log10(power ratio); key unchanged.

Question 23: answer and source

A source of 500 Kilo Ohms output impedance was to be connected to a load of 10 Ohms. The matching device or circuit could be of two types: a CC stage in between, or a passive circuit with input and output impedances of 500 kilo ohms and 10 ohms. Finally, CC stage is preferred even though it demanded more component count and circuit complexity. Why ?

Answer: It does not alter circuit conditions because of its voltage gain being unity.

An emitter follower (CC) buffers with unity voltage gain, so it does not disturb circuit conditions; key unchanged. Fixed misprint 'preffered' and removed duplicated sentence.

Question 24: answer and source

Mark the reason for CB configuration having very small input impedance

Answer: That input is applied between emitter and base and emitter junction is always forward biased for operation

The CB input looks into the forward-biased emitter junction, hence very low input impedance; key unchanged. Fixed misprint 'emiiter'.

Question 25: answer and source

The power handling capability of a given transistor, is dependent upon which of the following ?

Answer: Maximum junction temperature and expected ambient temperature.

Allowed dissipation depends on both the maximum junction temperature and the ambient temperature (derating); key unchanged.

Question 26: answer and source

It is desired to design an amplifier with a voltage gain of 10,000. Output should be in phase with the input. Available CB stage has a gain of 100 per stage and CE has per stage gain of 25. The designed amplifier shall have

Answer: Two cascaded stages of CB configuration

Two CB stages give 100 x 100 = 10,000 and CB is non-inverting, so output stays in phase; four CE stages would give 25^4 = 390,625. Legacy keyed 'Four cascaded stages of CE'.

Question 27: answer and source

H-parameters of a transistor

Answer: Are dependent upon collector current

H-parameters are specified at an operating point and depend on collector current; key unchanged.

Question 28: answer and source

High frequency response of a transformer coupled amplifier is generally limited by

Answer: Transformer's leakage inductance and distributed capacitance

Leakage inductance with distributed (winding) capacitance limits the high-frequency end; key unchanged.

Question 29: answer and source

Low frequency response of a transformer coupled amplifier is limited by

Answer: Transformer's primary inductance

The shunting effect of finite primary (magnetizing) inductance limits low frequencies; key unchanged.

Question 30: answer and source

In a voltage series feedback

Answer: Output resistance decreases while input resistance increases

Series mixing raises input resistance; voltage sampling lowers output resistance; legacy keyed 'both reduced'.

Source 1

Question 31: answer and source

Which coupling produces the minimum interference with frequency response ?

Answer: Direct Coupling

Direct coupling has no reactive coupling elements, so it disturbs the frequency response least; key unchanged.

Change log: 17 November 2026

Original question numbers and review decisions
  • Original Q1: verified as keyed. A clipper cuts off the part of the waveform above or below a reference level, giving a smaller amplitude output; key unchanged.
  • Original Q2: verified as keyed. Faithful pulse amplification needs a wide bandwidth to preserve fast rise times; legacy keyed 'Narrow Band'.
  • Original Q3: verified as keyed. A larger RC time constant keeps the sweep on the initial, nearly linear part of the exponential; key unchanged.
  • Original Q4: verified as keyed. A class-C tuned amplifier's short conduction angle is rich in harmonics, selected by the tuned tank; key unchanged. Fixed misprints 'gerneration'/'Turned'.
  • Original Q5: verified as keyed. Zener diodes are heavily doped to give a thin depletion region and sharp breakdown; key unchanged.
  • Original Q6: verified as keyed. Ampere's law around a long straight conductor: H = I / (2 pi r); key unchanged.
  • Original Q7: verified as keyed. Air is non-magnetic and its relative permeability is taken as unity in engineering work (vacuum is exactly 1; bismuth is diamagnetic, cobalt ferromagnetic); legacy keyed 'Cobalt'.
  • Original Q8: verified as keyed. tan(theta_B) = sqrt(2) = 1.414, so theta_B = 54.7 degrees; key unchanged. Fixed misprint 'paralled'.
  • Original Q9: verified as keyed. mu0 = 4 pi x 10^-7 H/m; key unchanged.
  • Original Q10: verified as keyed. Atmospheric absorption is strongly frequency dependent; key unchanged.
  • Original Q11: verified as keyed. Plasma is an ionized gaseous medium; key unchanged.
  • Original Q12: verified as keyed. Circular polarization needs equal-amplitude orthogonal components in 90 degree phase difference; key unchanged.
  • Original Q13: verified as keyed. v = c / sqrt(Er) = 3 x 10^8 / 2 = 1.5 x 10^8 m/s; key unchanged.
  • Original Q14: verified as keyed. Gamma = (1 - sqrt(2.2)) / (1 + sqrt(2.2)) = -0.483/2.483 = -0.195; legacy keyed -0.255.
  • Original Q15: verified as keyed. VSWR ranges from 1 (matched) to infinity (total reflection); key unchanged.
  • Original Q16: verified as keyed. Coulomb's law is inverse square: doubling distance quarters the force; key unchanged.
  • Original Q17: corrected. For a good conductor n = sqrt(sigma / (2 x 2 pi f x e0)) = sqrt(5.8e7 / 1.113e-3) = 2.28 x 10^5. The legacy options had lost their exponents (2.27 / 22.7 / 227 / 2270); repaired with the correct powers of ten.
  • Original Q18: verified as keyed. Poynting density S = E^2 / eta; with eta = 377 ohms, S = (30 kV/m)^2 / 377 = 2.39 x 10^6 W/m^2 = 2390 KW/m^2 (GATE ECE 2001 pattern). The stated mur = 4 does not enter the corpus computation; option units should read per square metre.
  • Original Q19: verified as keyed. Iron, cobalt and nickel are the common ferromagnetic metals; key unchanged.
  • Original Q20: verified as keyed. A frequency response curve plots output (gain) against frequency; key unchanged.
  • Original Q21: verified as keyed. A FET is a voltage-controlled device with a high-impedance gate; key unchanged.
  • Original Q22: verified as keyed. The decibel is defined as 10 log10(power ratio); key unchanged.
  • Original Q23: verified as keyed. An emitter follower (CC) buffers with unity voltage gain, so it does not disturb circuit conditions; key unchanged. Fixed misprint 'preffered' and removed duplicated sentence.
  • Original Q24: verified as keyed. The CB input looks into the forward-biased emitter junction, hence very low input impedance; key unchanged. Fixed misprint 'emiiter'.
  • Original Q25: verified as keyed. Allowed dissipation depends on both the maximum junction temperature and the ambient temperature (derating); key unchanged.
  • Original Q26: verified as keyed. Two CB stages give 100 x 100 = 10,000 and CB is non-inverting, so output stays in phase; four CE stages would give 25^4 = 390,625. Legacy keyed 'Four cascaded stages of CE'.
  • Original Q27: verified as keyed. H-parameters are specified at an operating point and depend on collector current; key unchanged.
  • Original Q28: verified as keyed. Leakage inductance with distributed (winding) capacitance limits the high-frequency end; key unchanged.
  • Original Q29: verified as keyed. The shunting effect of finite primary (magnetizing) inductance limits low frequencies; key unchanged.
  • Original Q30: verified as keyed. Series mixing raises input resistance; voltage sampling lowers output resistance; legacy keyed 'both reduced'.
  • Original Q31: verified as keyed. Direct coupling has no reactive coupling elements, so it disturbs the frequency response least; key unchanged.